Sharp SDW6747GS, Руководство по установке

Страница: 4 / 12

4
PREPARE ELECTRICAL WIRING
WARNING
FOR PERSONAL SAFETY: Remove house fuse or
open circuit breaker before beginning installation.
Do not use an extension cord or adapter plug with
this appliance.
ELECTRICAL REQUIREMENTS
• This appliance must be supplied with 120V, 60 Hz. It must be
connected to an individual properly grounded branch circuit and
protected by a 15 or 20 ampere circuit breaker or time delay fuse.
• Wiring must be 2-wire with ground.
• If the electrical supply does not meet the above requirements,
call a licensed electrician before proceeding.
GROUNDING INSTRUCTIONS – CABLE DIRECT
This appliance must be connected to a grounded metal, permanent
wiring system, or an equipment grounding conductor must be run
with the circuit conductors and be connected to the equipment
grounding terminal or lead on the appliance.
GROUNDING INSTRUCTIONS – POWER CORD
MODELS
This appliance must be grounded. In the event of a malfunction
or breakdown, grounding will reduce the risk of electric shock by
providing a path of least resistance for electric current. The plug must
be plugged into an appropriate outlet that is installed and grounded
in accordance with local codes and ordinances.
WARNING
The improper connection of the equipment grounding
conductor can result in a risk of electric shock. Check
with a qualified electrician or service representative if
there is doubt that the appliance is properly grounded.
White
24"
From Wall
Ground
Black
1
1
/
2
" Dia.
Hole (Max.)
2
1
/
2
" - 3
1
/
2
"
From
Cabinet
FIGURE E
INSTALLATION INSTRUCTIONS
CABINET PREPARATION & WIRE ROUTING
• The wiring may enter the opening from either side, rear or the
floor within the shaded area.
• Cut a 1
1
/
2
" maximum diameter hole to allow the electrical cable.
The hole must be free of sharp edges. If the cabinet wall is metal,
the hole edge must be covered with a bushing.
• Cable direct connections may pass through the same hole as
the drain hose and hot water line, if convenient. If cabinet wall
is metal, the hole edge must be covered with a bushing. NOTE:
Power cords with plug must pass through a separate hole.
ELECTRICAL CONNECTION TO DISHWASHER
Electrical connection is on the right front of dishwasher.
• For cable direct connections, the cable must be routed as shown in
Figure E. Cable must extend a minimum of 24" from the rear wall.
• For power cord connections, install a 3-prong grounding type
receptacle. The power supply receptacle for the appliance shall
be installed in a cabinet or on a wall adjacent to the under counter
space in which the appliance is to be installed.
PREPARE HOT WATER LINE
•
The line may enter from either side, rear or floor within the shaded
area shown in Figure F.
• The line may pass through the same hole as the electrical cable
and drain hose. Or, cut an additional 1
1
/
2
" diameter hole to
accommodate the water line. If a power cord with plug is used,
water line must not pass through power cord hole.
5
1 /
3
" - 7
1 /
3
"
From Cabinet
Shut-off
Valve
18" From Wall
3" From Floor
Cabinet Face
Hot
Water
Supply
Line
Power
Cable
5
1
/
3
" - 7
1
/
3
"
2
1 /
2
" - 3
1 /
2
"