7
1. Remove all packing materials including the
feature sticker (if applicable). The waveguide
cover prevents food and grease from entering
the waveguide area where it could cause damage.
DO NOT REMOVE THE WAVEGUIDE COVER.
2. The oven door will become hot during cooking.
Place or mount the oven so that the bottom
of the oven is 85cm or more above the floor.
Ensure the surface or mounting position is
strong enough to take the oven weight, plus the
heaviest item likely to be cooked in the oven.
3. The
minimum
height of free space
necessary above the
top surface of the
oven is 13cm. The
oven rear surface
should be placed against the wall.
4. Do not place the oven where heat, moisture
or high humidity are generated, (for example,
near or above a conventional oven) or near
combustible materials (for example, curtains).
Do not block or obstruct air vent openings. Do
not place objects on top of the oven.
5. Make sure the power supply cord is undamaged
(See “ELECTRICAL CONNECTION” below).
Do not allow the power supply cord to
run over any hot or sharp surfaces, such
as the hot air vent area at the top rear of
the oven.
6. The socket must be readily accessible so that it
can be easily unplugged in an emergency.
7. Do not use the oven outdoors.
BUILDING-IN-KIT.
This oven is designed for counter top or built-in use.
Do not place the oven in a cabinet.
An installation frame is available which enables the
microwave oven to be integrated within a kitchen
unit.
The microwave oven is not designed to be built
above or near a conventional oven.
SHARP recommend the use of the build in kit
EBR-
9910
available from your SHARP dealer. Only the
use of this frame will guarantee the quality and
safety of the oven.
ELECTRICAL CONNECTION.
• Do not allow water to come into contact with
the power supply cord or plug.
• Insert the plug properly into the socket.
• Do not connect other appliances to the same
socket using an adaptor plug.
• If the power supply cord is damaged, it must be
replaced by a Sharp approved service facility or a
similarly qualified person to avoid a hazard.
• When removing the plug from the socket always
grip the plug, never the cord as this may damage
the power supply cord and the connections inside
the plug.
• If the plug fitted to your oven is a rewireable
type and in the event of the socket outlet in
your home not being compatible with the plug
supplied, remove the plug properly (do not cut
off).
• If the plug fitted to your oven is a non-rewirable
type and in the event of the socket outlet in your
home not being compatible with the plug supplied,
cut-off the mains plug.
• Refit with a suitable type, observing the wiring
code given in ‘To replace the mains plug’ on page
38.
13cm
IMPORTANT!
• The fuse from the cut-off plug should be removed
and the plug disposed of in a safe manner.
• Under no circumstances should the cut-off plug
be inserted into a socket outlet as a serious
electric shock may occur.
• The plug must not be used without the fuse cover
fitted.
• If you have any doubt about your microwave oven
obtain the help of a qualified electrician.
• When replacing the plug please ensure that you
use a BSI or ASTA approved plug to BS1363, this
should be fitted with a brown coloured 13 amp
fuse approved by BSI or ASTA to BS1362. If you
have any doubt about electrical connection seek
the help of a qualified electrician.
WARNING: THIS APPLIANCE MUST
BE EARTHED
To wire an appropriate plug, follow the wiring
code given in ‘To replace the mains plug’ on page
38.
INSTALLATION
R-959(SL)M-AA.indb 7
R-959(SL)M-AA.indb 7
2/13/13 2:50:05 PM
2/13/13 2:50:05 PM