42
TROUBLESHOOTING
ANSWER
When the oven is working, air circulates within the cavity.
The door does not form an airtight seal so air may escape from the door.
The oven cavity will normally be colder than the food being cooked, and so
steam produced when cooking will condense on the colder surface.
The amount of steam produced depends on the water content of the food
being cooked. Some foods, such as potatoes have a high moisture content.
Condensation trapped in the door glass should clear after a few hours.
Arcing will occur when a metallic object comes into close proximity to
the oven cavity during cooking. This may possibly roughen the surface of
the cavity, but would not otherwise damage the oven.
Ensure all “eyes” are removed from the potatoes and that they have been
pierced, place directly onto the turntable or in a heat resistant flan dish or
similar.
Check the door is closed properly.
Ensure correct power level has been selected.
The microwave energy pulses ON and OFF during cooking/defrosting.
The cabinet may become warm to the touch - keep children away.
Your oven may be set in Demo Mode. Follow these steps to cancel the
demo mode.
1. Press the
STOP/CLEAR
key once.
2. Press and hold the
STOP/CLEAR
key for 10 seconds until you hear
until you hear the oven beep for a second time.
3. Quickly press the
STOP/CLEAR
key 10 times within 10 seconds.
4. The oven display will show “DEMO OFF”.
QUERY
Draught circulates
around the door.
Condensation forms in
the oven, and may drip
from the door.
Flashing or arcing from
within the cavity when
cooking.
Arcing potatoes.
The display is lit but the
control panel will not
work when pressed.
Oven cooks too slowly.
Oven makes a noise.
Outer cabinet is hot.
The display shows
different messages from
“ENERGY SAVE MODE”
when you plug the oven
in and open the door.
You are unable to
programme your oven
or the microwave energy
does not pulse on and
off during use.
TROUBLESHOOTING CHART
VJCM Modular Op Man 23/01/2003 14:45 Page 42