Sharp R-671(B), Руководство по обслуживанию

Страница: 18 / 45

R-671 - 17
PROCEDURE
LETTER
COMPONENT TEST
If the fuse F8A (F2) is blown by incorrect door switching replace the defective switch(es) and the fuse
F8A (F2).
CARRY OUT 4R CHECKS.
CAUTION: Only replace fuse with the correct value replacement.
I NOISE FILTER TEST
CARRY OUT 3D CHECKS.
Disconnect the leads from the terminals of noise filter.
Using an ohmmeter, check between the terminals as
described in the following table.
MEASURING POINTS INDICATION OF OHMMETER
Between N and L Approx. 680 k Ω
Between terminal N and WHITE Short circuit
Between terminal L and RED Short circuit
If incorrect readings are absorbed, replace the noise filter unit.
CARRY OUT 4R CHECKS.
LINE BYPASS
CAPACITOR
4700p/250V LINE BYPASS
CAPACITOR
4700p/250V
NOISE SUPPRESSION COIL
RESISTOR 680K/0.5W
10M/0.5W
LINE CROSS CAPACITOR
0.22
µ /250V
F1:
FUSE 15A
F2: FUSE F8A
NOISE
FILTER
L N
WHT RED
J MOTOR WINDING TEST
CARRY OUT 3D CHECKS.
Disconnect the leads from the motor. Using an ohmmeter, check the resistance between the two
terminals as described in the table below.
Table: Resistance of Motor
Motors Resistance
Fan motor Approximately 300 Ω
Turntable motor Approximately 14.9 k Ω
If incorrect readings are obtained, replace the motor.
CARRY OUT 4R CHECKS.
K GRILL HEATING ELEMENT (TOP) AND BOTTOM HEATING ELEMENT TEST
CARRY OUT 3D CHECKS.
Before carrying out the following tests make sure the heating element is cool completely.
1. Resistance of heating element.
Disconnect the wire leads to the heating element to be tested. Using ohmmeter with low resistance
range. Check the resistance across the terminals of the heating element as described in the
following table.
Table: Resistance of heating element
Parts name Resistance
Grill heating element (top) Approximately 76 Ω
Bottom heating element Approximately 132 Ω
2. Insulation resistance.
Disconnect the wire leads to the heating element to be tested. Check the insulation resistance
between the element terminal and cavity using a 500V - 100M
Ω insulation tester. The insulation
resistance should be more than 10 M Ω in the cold start.
If the results of above test 1 and/or 2 are out of above specifications, the heating element is probably
faulty and should be replaced.
CARRY OUT 4R CHECKS.
TEST PROCEDURES
CONT
...