Sharp R-360EG, Руководство по обслуживанию

Страница: 27 / 40

25
R-360EG
R-360ES
R-360EW
R - 360EZ
1. Disconnect the power supply cord.
2. Remove turntable and turntable support from oven cavity.
3. Lay the oven on it's backside. Remove the turntable
motor cover by snipping off the material in four corners.
4. Where the corners have been snipped off bend corner
areas flat.
5. Disconnect wire leads from turntable motor.
(See "Positive lock connector removal")
6. Remove two (2) screws holding turntable motor to oven
TURNTABLE MOTOR REMOVAL
cavity.
7. Remove the TTM packing from the turntable motor
shaft.
8. Now the turntable motor is free.
9. After replacement use the one (1) screw to fit the
turntable motor cover.
CAUTION: NO SHARP EDGES MUST BE EVIDENT AF-
TER REMOVAL OF THE TURNTABLE MO-
TOR COVER.
1. Disconnect the power supply cord, and then remove
outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Push the lever of positive lock
® connector.
5. Pull down on the positive lock ® connector.
CAUTION: WHEN CONNECTING THE POSITIVE LOCK ®
CONNECTORS TO THE TERMINALS, CON-
NECT THE POSITIVE LOCK
® SO THAT THE
LEVER FACES YOU
POSITIVE LOCK
®
CONNECTOR (NO-CASE TYPE) REMOVAL
Figure C-3. Positive lock ® connector
Terminal
Push
Pull down
1
2
Lever
Positive lock®
connector
5. Install the fan blade to the shaft of fan motor by pushing
the fan blade with a small, light weight, ball peen hammer
or rubber mallet.
CAUTION:
*
Do not hit the fan blade strongly when installed
because the bracket may be disfigured.
* Make sure that the fan blade rotates smooth after
installation.
* Make sure that the axis of the shaft is not slanted.
6. Catch two holes of fan duct on two tabs of the base plate.
7. Hold the fan duct assembly to the base plate with the two
(2) screws.
8. Re-install the separete angles A, B and C to the base
plate with each one (1) screw.
9. Insert the main wire harness and switch harness into the
holes and switch harness of the fan duct.
10.Connect the wire leads to the fan motor. Referre to
"PICTORIAL DIAGRAM".
11.Re-install the oven cavity assembly to the base plate.
Refere to "OVEN CAVITY ASSEMBLY REMOVAL".
12.Reconnect all wire leads removed from components.
Referre to "PICTORIAL DIAGRAM".
Gap
Rotor
Bracket
Stator
Groove joint pliers
Coil
Shaft
Axis
Stator
Rotor
These are the positions
that should be pinched
with pliers.
Shaft
Table
Center of
bracket
Side View
Rear View
POWER UNIT REMOVAL
1. Disconnect the power supply cord and remove outer
case.
2. Open the door and back it open.
3. To discharge the high voltage capacitor, waite for 60
seconds.
4. Disconnect the wire leads and the connectors from the
power unit.
5. Remove two (2) screws holding power unit to the base
plate.
6. With needle nose pliers, nip and push the head of the
one (1) PC support clip which holds the power unit. And
then release the clip from the hole of the power unit.
7. Now the power unit is free.
Figure C-2. PC support clip
Needle nose pliers
Power unit
PC support clip