E-11
ENG
CARE AND MAINTENANCE
UNIT
FILTER INDICATOR LIGHT
The Filter Indicator Light will illuminate as a reminder to perform maintenance
of the Back Panel, Sensors, and Humidifying Filter. The Indicator Light will turn
on after approximately 720 hours of use.
After performing maintenance, reset the Filter Indicator. Plug the unit in, turn
power ON, and press the RESET button for 3 seconds. The Filter Indicator
Light will go off. Even if the Filter Indicator Light is already off, the RESET but-
ton should be pressed to reset the maintenance timer.
BACK PANEL and SENSORS
Sensor
Back Panel
Sensor Filter
To maintain optimum performance of this air puri
fi
er, please clean the unit including
the sensor and
fi
lters periodically.
When cleaning the unit, be sure to
fi
rst unplug the power cord, and never handle the
plug with wet hands. Electrical shock and/or bodily injury may occur as a result.
Back Panel
Care Cycle
After 720 hours of use
(
30days × 24hours = 720)
Care Cycle
Whenever dust accumulates
on the unit or every 2 months
Gently remove dust from the sensor opening and the
back panel, using a vacuum cleaner attachment or
similar tool.
When the back panel has stubborn dirt
1
In case of oily dirt, soak the back panel in water with
kitchen detergent.
Avoid scrubbing the back panel hard when washing.
2
Rinse the back panel repeatedly with clean water to re-
move the solution residue.
3
Drip dry
fi
lter to remove excess water.
SENSOR FILTER CARE
Remove the sensor filter and tap it lightly over a sink
or bin to dislodge dust. If it is very dirty, wash it gently
with lukewarm water.
Do not use any detergents or
chemicals of any kind to clean the
fi
lter.
Dry the
fi
lter
completely before replacing in the unit. Do not operate
unit without all
fi
lters properly installed.
Care Cycle
Whenever dust accumulates on the unit or every 2 months
To prevent dirt or stains on the unit, clean regularly. If stains are allowed to remain, they may
become dif
fi
cult to remove.
Wipe with a dry, soft cloth
For stubborn stains or dirt, use a soft cloth dampened with warm water.
Do not use volatile
fl
uids
Benzene, paint thinner, polishing powder, may damage the surface.
Do not use detergents
Detergent ingredients may damage the unit.
KC-840E̲Eng2.indd Sec1:11
KC-840E̲Eng2.indd Sec1:11
2009/09/24 13:19:28
2009/09/24 13:19:28
Содержание Plasmacluster KC-840E
Страница 143: ...RUS ...
Страница 243: ...J 19 JPN ...
Страница 264: ...KC 840E KC 850E KC 860E KC 840E KC 850E KC 860E Plasmacluster is a trademark of Sharp Corporation ...