Sharp PG-C45X - Notevision XGA LCD Projector, Руководство по эксплуатации

Страница: 39 / 107

Image Projection
▼
Keycode input box
-34
Lamp
replacement
indicator
Power
indicator
INPUT
button
'
,
"
,
\
,
|
buttons
MENU
button
ENTER
button
Power (ON)
button
INPUT
buttons
'
,
"
,
\
,
|
buttons
MENU button
ENTER
button
Power (OFF)
button
Basic Procedure
Connect the required external equipment to the pro-
jector before operating the following procedures.
Info
•
The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page
36 .
1
Plug the power cord into the
wall outlet.
•
The power indicator illuminates red, and
the projector enters standby mode.
2
Press
ON
on the projector or on
the remote control.
•
The power indicator illuminates green.
After the lamp replacement indicator il-
luminates, the projector is ready to start
operation.
Note
•
The lamp replacement indicator il-
luminates, indicating the status of the
lamp.
Green: The lamp is ready.
Green blinking: The lamp is
warming up.
Red: The lamp should be replaced.
•
If the power is turned off and immediately
switched on again, the lamp replacement
indicator may take time to illuminate.
•
When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds
after the power has been turned on,
and then transmit the commands.
When “Anti-Theft” (see page 75 ) is set,
the keycode input box will appear.
•
Enter the keycode.
Note
•
When entering the keycode, press
the buttons previously set on the
projector or the remote control.
Info
•
When “Anti-Theft” is set, enter the
keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (see page
75 .)
Power (ON)
button
Power (OFF)
button