Sharp NS-F128G6, Руководство пользователя

Страница: 3 / 21

MTA14004
１
1. SCOPE
This document describes the specifications of solar module NS-F121G6
2. APPLICATION STANDARD
This module is designed to meet the requirement of the following standards.
・
IEC 61646 Ed.2 Thin film PV modules – Design qualification and type approval.
・
EN 61730-1 Photovoltaic (PV) module safety qualification
Part 1: Requirements for construction
・
EN 61730-2 Photovoltaic (PV) module safety qualification
Part 2: Requirements for testing
3. REFERENCES
3.1 Normative References
The following normative documents contain the provisions which, through reference in this
text, constitute provisions of this specification. At the time of publication, the editions
indicated were valid. All normative documents are subject to revision, and parties to
agreements based on this specification are encouraged to investigate the possibility of
applying the most recent editions of the normative documents indicated below.
・
IEC 60904-1 Photovoltaic devices - Part 1: Measurement of photovoltaic current-voltage
characteristics.
・
IEC 60904-3 Photovoltaic devices - Part 3: Measurement principles for terrestrial
photovoltaic (PV) solar devices with reference spectral irradiance data.
・
IEC 60904-9 Photovoltaic devices - Part 9: Solar simulator performance requirements.
・
JIS C8939 Amorphous solar PV modules
・
JIS C8991 Thin-film terrestrial photovoltaic (PV) modules – Design qualification and
type approval
3.2 Installation Manual: Document No. KTA10003-A Ver. 3.11
3.3 Instruction for the usage of thin-film PV module regarding “White Spot”
: Document No. MTL11037a and MTL11041A
4. SPECIFICATION
4.1 Application class
This module is applied to application class A in accordance with EN 61730.
4.2 Materials
The materials used for the module shall comply with this specification and unless otherwise
specified, the ones that fully meet the requirement of this specification shall be used in any
case.
4.2.1 Solar cells
Solar cells shall be produced from amorphous silicon (a-Si:H) and micro-crystalline silicon (
μ
c-Si). The cell has the a-Si /
μ
c-Si tandem structure.
4.2.2 Interconnectors
Interconnectors shall be solder coated copper.
4.2.3 Filling materials