Sharp Notevision XG-P10XE, Руководство по обслуживанию

Страница: 31 / 119

31
XG-P10XE
No. Adjusting point Adjusting conditions Adjusting procedure
37 Thermistor
performance
check 1. Heat the thermistor using a
dryer.
»
Make sure the “TEMP” is displayed.
38 Automatic
synchronization 1. Receive the PHASE check
pattern signal.
»
Call the VGA/S-VGA/XGA mode and make sure
that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
S3 “Factory setting 3”
Remote controller
setting
Process
adjustment
»
Make the following settings. 40 Factory settings
39 Keystone
correction
performance
check
»
Make sure the keystone correction functions well.
36 Off-timer
performance
check
»
In the process mode and select OFF. Make sure that
the off-timer starts with “5” (minutes), counts down
each minute in 1 second, and turns off the set at “0”.
35 RGB
performance
check 1. Receive the RGB signal.
»
In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
34 Audio system
performance
check
»
In the process mode nad select L3. Check the bass,
treble and balance.
33 Video system
performance
check 1. Receive the monoscope
pattern signal.
»
In the process mode and select L2. Check the pic-
ture, brightness and sharpness.
32 Colour system
performance
check 1. Receive the colour bar sig-
nal.
»
In the process mode and select L1. Check the col-
our and tint.
31 Checking and
readjustment of
white balance 1.The adjustment condition of
each item is as mentioned
in the following.
RGB input:Refer to No.13
VIDEO input:Refer to No.23
DVD input:Refer to No.28
2. A digital television does
compensation adjustment
by using "CR-OFFSET" or
"CB-OFFSET".
»
Make sure that a white balance is the best condi-
tion.
»
Make this adjustment after finishing the above ad-
justment.