Sharp NoteVision PG-LS2000, Руководство по эксплуатации

Страница: 60 / 75

58
4
Remove the lamp unit.
Loosen the securing screw from the lamp
unit. Hold the lamp unit and pull it in the
direction of the arrow. At this time, keep
the lamp unit horizontal and do not tilt it.
5
Insert the new lamp unit.
Press the lamp unit fi rmly into the lamp unit
compartment to align the lamp connectors.
Fasten the securing screw.
6
Replace the lamp unit cover.
Slide the lamp unit cover horizontally back
into place and align the tabs (
1
). Then
tighten the user service screw (
2
) to
secure the lamp unit cover.
Info
If the lamp unit and lamp unit cover
are not correctly installed, the power
will not turn on, even if the power
cord is connected to the projector. •
Resetting the Lamp Timer
Reset the lamp timer after replacing the lamp.
Info
Make sure to reset the lamp timer only when
replacing the lamp. If you reset the lamp timer
and continue to use the same lamp, this may
cause the lamp to become damaged or
explode. •
1
Connect the power cord.
Plug the power cord into the AC socket of
the projector.
2
Reset the lamp timer.
While simultaneously holding down
MENU , ENTER and
R
on the projector,
press STANDBY/ON on the projector and
keep all four buttons pressed down until
the lamp indicator starts blinking green.
“LAMP 0000H” is displayed, indicating
that the lamp timer is reset.
•
•
•
•
•
•
4
5
6
AC socket AC socket
1
ENTER button
MENU button
R
button
STANDBY/ON
button
ENTER button
MENU button
R
button
STANDBY/ON
button
2
Regarding the Lamp (Continued)
Securing
screw