MX-M264U MX-TR11 (JOB SEPARATOR) 9 – 2
7)
Remove the paper holding arm, install it to job separator AS.
(Same as the current state)
8)
Install the second paper exit tray holder. (New part)
M4 P tight tightening
9)
Install the job separator tray AS.
10) Install the rail dummy cover part to the guide rail so that slide
the over part from front side to rear side.
After that, insert the rib of tray part to the location of insertion of
the second paper exit tray holder.
Check that it is caught while being pushing up the tray.
11) Install the right cabinet AS.
M4 x 10 P tight (2pcs)
12) Install the rear cabinet.
13) Job separator setting in simulation 26-1.
Paper holding arm