MX-CFX1 OPERATIONAL DESCRIPTION 5 – 4
16) The reverse sensor is turned OFF. The trailing edge of the
sheet is detected, and the flapper solenoid in the reverse sec-
tion is turned OFF. When the sheet travels a predetermined
distance, the reverse motor stops.
[Exiting from reverse section]
17) When the reverse motor has completely stopped, the reverse
motor starts to reverse, and the transport motor starts.
18) The reverse sensor is turned ON, and detects the leading
edge of the sheet.
19) The paper exit sensor is turned ON, and detects the leading
edge of the sheet.
20) The reverse sensor is turned OFF. When the sheet travels a
predetermined distance after its trailing edge is detected, the
reverse motor stops.
(If the next sheet waits at the leading-edge registration posi-
tion, the flapper solenoid in the reverse section is turned ON,
the paper feed motor starts to rotate in the forward direction,
and the reverse motor starts to rotate in the forward direction.)
[Paper exit]
21) The paper exit sensor is turned OFF, and the trailing edge of
the sheet is detected.
22) If there is no next sheet to be inserted, the transport motor
stops.
4. Offline mode setting
A. How to set punching mode
The figure below shows the operator panel.
Setting procedure:
1)
Place a sheet in the tray.
2)
Press the PUNCH switch on the operator panel.
3)
The PUNCH LED lights up to indicate that setting has been
completed.
4)
Press the START switch to start operation.
Canceling procedure:
5)
Press the PUNCH switch on the operator panel.
6)
The PUNCH LED goes out to indicate that setting has been
canceled.
NOTE: If you cannot make or cancel setting by following the
respective procedures above, refer to "5. LED indication on
operation panel" shown later. When no LEDs are lit, check
the setting made by the main unit and the inserter status.
B. How to set stapling mode
Punch switch
Punch LED
Start switch
Start LED
Start switch
Staple mode switch
Start switch
Staple mode LED 4
Staple mode LED 3
Staple mode LED 2
Staple mode LED 1
