EN
panel must be a minimum of 25 mm.
The dimensions and material of the
cabinet in which the oven will be ins-
talled must be correct and resistant to
increases in temperature. In a correct
installation, contact with electrical or
insulated parts must be prevented. In-
sulating parts need to be fitted in a way
to ensure that they cannot be removed
by using any kind of tool. Installing the
appliance in the close vicinity of a refri-
gerator or a deep-freezer is not recom-
mended. Otherwise, the performance
of the above-m entioned
appliances
will be negatively affected due to ema-
nating heat. After removing your oven
from its packaging, be sure that the
oven is not harmed. In case, you sus-
pect of any damage to the appliance,
do not use it; immeditely contact Autho-
rized Service.
POSITIONING THE BUILT-IN
HOB
In order to prevent leakage of any liquids
on the counter, a special sealing putty is
supplied together with your oven. Apply
tihs putty around the clearance on the
kitchen counter, measured in the size
indicated in the Figure 2. Extend the fi
-
ve-piece putty by stretching and apply it
around the clearance. Place the hob on
it, with its control buttons being on the
right side. Make sure to fit the clamps
as shown in the Figure 3. After fitting
your hob into its place, neatly remove
the excess sealing putty around the si-
des with the help of a spatula(Figure 3).
In case the thickness of the kitchen co-
unter is less than 40mm, use the clamp
as shown in the Figure 4. Place your
hobs directly into the opening gap( Fi-
gure 5a-5b)
520mm
590mm
560mm
150mm
Min.60mm
490mm
Min.50mm
–
Faulty wiring may damage the appli-
ance. Such damage will not be cove-
red under the warranty.
–
The appliance is designed to connect
to 220-240V~. If the electricity is diffe-
rent than the value given above, call
the Authorized Service Centre imme-
diately.
The manufacturer declares that
its bears no liability of any kind for
damage and loss arising from not
complying with safety standards!
The instructions given below must be
followed without fail during wiring :
The earthing cable must be connected
via the screw with the earthing mark.
Supply cable connection must be as
shown in Figure 6. If there is no earthed
outlet conforming to regulations in
the installation environment, call the
Содержание KA-62V19IM0-EU
