7
13
3 1⁄4” x 10” Ducted Discharge Only: Remove
tape
from
damper flap and attach
Damper/Duct Connector
over
knockout opening with screws removed in Step 4 under
“PREPARE THE HOOD”. Make sure damper
Pivot
is
nearest to
top/back edge
of hood.
14
7” Round Ducted Discharge Only: Re-install 7” Round
Duct Plate removed in Step #1 under “PREPARE
THE HOOD”. Install a 7” Round Damper (purchase
separately). Damper flap must open freely in direction
of airflow (away from range hood).
Note:
To accommodate off-center ductwork, the Damper/
Duct Connector can be installed up to 1-inch on either side
of hood center or the 7” Round Duct Plate can be installed
up to 1⁄2” on either side of hood center. In extreme off-center
installations, one end of the duct connector may need to be
trimmed to clear the electrical cable clamp.
PREPARE THE HOOD
10
Re-install air chute and screw, re-connect wire harness
and replace light panel.
Note
: Be careful not to trap wires between
Support Fin
and light panel.
11
Remove appropriate
Duct Knockout(s)
from top or back
of hood.
12
Horizontal Discharge Only: Remove the
Plate
in front of
the horizontal discharge knockout. Cut the
ties
, lift plate
out, and discard plate. DO NOT REMOVE the
Metal
Strip
held in place with two
screws
.
