6
NON-DUCTED INSTALLATION - Skip to page 8.
The following Steps (6 thru 14) are for DUCTED
INSTALLATION ONLY.
6
Remove
Light
Panel
- held in
place with
(5) #8
screws.
Disconnect
light assembly
w i r e h a r n e s s
(white connector).
7
Remove
Air Chute
- held in place with
one (1) screw.
Note
: Be careful
not to disconnect
any wires.
8
Remove
Baffle
from air chute.
1
Remove
7” Round
Duct Plate
from top
of hood. Set duct
plate aside - with
mounting screws.
2
R e m o v e t a p e
holding
Filters
in
place. Pull down
on filter tabs or
finger holes and
lift filters out. Set
filters aside.
3
Remove
Teflon
®
-
Coated Bottom
Cover
from hood.
S et c ove r a nd
mounting screws
aside.
Teflon
®
is a registered
trademark of DuPont.
4
Remove
Damper/
Duct Connector
from inside the
hood. Set connector
aside - with mounting
screws and parts
bag.
5
Remove either top
or back wiring
knockout and install
approved
Electrical
Cable Clamp
.
PREPARE THE HOOD
TEFLON
®
-COATED BOTTOM COVER
(Held in place with 2 screws)
DAMPER/ DUCT CONNECTOR
ELECTRICAL CABLE CLAMP
9
Rotate baffle.
Reinsert baffle
into air chute
(as shown) so
that baffle
Tabs
fit all the way
into
Slots
in air
chute. An audible
“click” will be
heard when fully
installed. This
will close off the
air flow through
the non-ducted
slots on top of
hood.
