E-3
To mount the sound bar on the wall
Caution:
Be very careful to prevent the sound bar [5.07 lbs.
(2.3 kg)] from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not
put on the veneer plaster or whitewashed wall. The
sound bar may fall.) If unsure, consult a qualified
service technician.
Mounting screws are not supplied. Use appropri-
ate ones.
Check all wall mount angle screws for looseness.
Select a good location. If not, accidents may occur
or the sound bar may get damaged.
SHARP is not responsible for accidents result-
ing from improper installation.
Driving screws
■
SHARP designed the sound bar so you may hang
it on the wall. Use proper screws (not supplied).
See below for size and type.
1/8” (3.2 mm)
3/8” (9 mm)
Min. 7/8” (22 mm)
3/16”
(5 mm)
Installing the sound bar
■
Fix the pattern paper to the wall in hori-
zontal position as below.
44 mm
509 mm
Wall
surface
Pattern paper
(supplied)
548 mm
●
●
●
●
●
●
Make a hole on the wall following the screw
point marks on the pattern paper by using
a drill.
Wall surface
1-1/4” (32 mm)
3/8” (8-9 mm)
2
Fix a wall mount plug into the hole using
a hammer, until it is flush with the wall
surface.
1-1/4” (32 mm)
3/8” (8-9 mm)
Wall surface
3
Fasten the screws to the wall as shown below.
(Total screw is 2 pieces)
Screw using
Wall surface
Wall surface
Screwdriver
4.5mm - 5mm
Gap from
wall surface
Hang the sound bar onto the screws.
System preparation
