Sharp FU-888SV, Руководство по эксплуатации

Страница: 8 / 32

INSTALLATION
HOW TO PUT THE UNIT ON A
TABLE
MOUNTING THE STAND
1
Remove the front panel.
• At the same time, also remove the pre-
filter, stamina-power carbon and the
HEPA filter.
Front panel
2
Place the unit with its front
side facing down on a flat
and stable surface.
• Place a soft cloth, etc., to prevent
damaging the unit.
3
Insert the tabs of the stand
into the holes of the main
unit and fix the stand using
the included thumbscrews
(2 pieses).
Holes
HOW TO MOUNT THE UNIT ON
A WALL
CAUTIONS
60cm or more away
from sidewall
CAUTION
WHEN MOUNTING THIS
PRODUCT TO A WALL
• Choose strong point on the wall with firm
piller or timber etc. for mounting.
• Never mount the unit to a thin wall or
plasterboard of insufficient strength. The
unit may drop as a result.
• When mounting the unit to a wall, remove
the front panel and hold the main unit.
Holding the front panel may cause it to
become detached, thus dropping the unit and
resulting in bodily injury.
• Do no install where there is generation of
lampblack, such as in a kitchen, etc.
The unit surface may crack or the sensors may
malfunction as a result.
1
Choose the mounting location
Leave space around the bracket by referring
to the illustration below. The unit cannot be
mounted if there is insufficient spacing
around the bracket.
75cm or more
69cm or more away
from the ceiling
Size of main
unit
75cm or more 75cm or more
M o u n t i n g
bracket 1
60cm or more away
from sidewall
E-6
Thumb-
screws
Tabs
1
2
1
Mount on a flat surface
• Do not mount the unit on a
location that is not flat such as
a wall with a door header, etc.
Do not mount the unit to a thin
wall with little support such as
a plasterboard, etc. The unit
may fall and will be very
dangerous.