Sharp DK-AP8P, Руководство по эксплуатации

Страница: 18 / 26

E-7
2009 September 17 DK-AP8P_A6_09 EN.fm
ENGLISH
DK-AP8P
Preparation f
or Use
Remote control
■
Batteries installation
Precautions for battery use:
●
Remove the batteries if the unit will not be used for a long
period of time. This will prevent potential damage due to
battery leakage.
Caution:
●
Do not use rechargeable batteries (nickel-cadmium battery,
etc.).
●
Danger of explosion if battery is incorrectly replaced.
●
Replace only with the same or equivalent type.
●
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
●
Installing the batteries incorrectly may cause the unit to
malfunction.
Notes concerning use:
●
Replace the batteries if the operating distance is reduced or
if the operation becomes erratic. Purchase 2X “CR 2032”,
coin lithium battery.
●
Periodically clean the transmitter on the remote control and
the sensor on the unit with a soft cloth.
●
Exposing the sensor on the unit to strong light may interfere
with operation. Change the lighting or the direction of the unit
if this occurs.
●
Keep the remote control away from moisture, heat, shock,
vibrations and any conductive materials to avoid malfunction.
■
Test of the remote control
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown
below:
1 Whilst pushing the locking tab towards the centre of the
remote control, slide out the battery holder.
2 Remove the old batteries from the battery holder, insert
two new batteries and then slide the battery holder back
into the remote control.
Back of remote control
Locking tab
Battery holder
Polarity (+) symbol
Battery type
Locking tab
Positive (+)
side up
ON/STAND-BY ESOUND
REVIEW
CURSOR VOLUME
CUE/
SKIP
PLA
Y MODE
ON/STAND-BY
ENTER E
SOUND
MENU TV DISPLAY SHUFFLE
15˚ 15˚
Remote sensor
0.2 m - 6 m
(8” - 20’)