Sharp CP-E1H, Руководство по эксплуатации

Страница: 4 / 16

E-
Note:
Before using remote control, please remove plastic shield
at battery holder.
Whilst pushing the locking tab towards the center
of the remote control, slide out the battery holder.
Remove the old battery from the battery holder,
insert the new battery and then slide the battery
holder back into the remote control.
1�
2�
Remote control - battery installation
Precautions for battery use:
Remove the battery if the unit will not be used for long
periods of time. This will prevent potential damage due to
battery leakage.
Caution:
Do not use rechargeable battery (nickel-cadmium
battery, etc.).
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Batteries (battery pack or battery installed) shall not
be exposed to excessive heat such as sunshine, fire
or the like.
Installing the battery incorrectly may cause the unit to
malfunction.
Notes concerning use:
Replace the battery if the operating distance is
reduced or if the operation becomes erratic. Purchase
“CR 2025”, coin lithium battery.
Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
Keep the remote control away from moisture, heat,
shock, and vibrations.
●
●
●
●
●
●
●
●
●
Battery holder
Remote
control
Plastic
shield
Polarity
(+) symbol
Battery type
Locking tab
Positive (+)
side up
General control
To turn the power on
■
Function Main unit
Remote
control
Operation
Power on/
off Press to turn the
power on or to
go to stand-by
mode.
Volume auto set-in
■
If you turn off and on the main unit with volume set to
16 or higher, the volume will start at 16.
If you turn the unit off then on again with the volume
level set to less than 16, it will turn on again at the
level set.
●
●
Volume control
■
Press the /– button to increase or decrease the
volume.
Extra bass control (X-BASS)
■
When the X-BASS button is pressed, the unit will enter the
extra bass mode which emphasises the bass frequencies
and “X-BASS” indicator will light up. To cancel the extra
bass mode, press the X-BASS button again.
Auto power off function
■
The main unit will enter the stand-by mode after 15 minutes
of inactivity during:
CD/USB: In the stop or pause mode.
TUNER: No reception of broadcast signal.
AUDIO IN: No detection of input signal.
Muting
■
The volume is muted temporarily when pressing the
MUTE button on the remote control. Press again to restore
the volume.
Battery holder
Locking tab
Back of remote
control