– 9 –
CD-K477W
(C
ont
inue
d)
■
FM/MW interval (span)
T
he I
n
te
rnat
ional T
elecom
m
uni
cat
ion
U
n
ion
(I
TU
) h
as
est
ab-
lished that member countries should maintain either a 10 kHz or
a 9 kHz interval between broadcasting frequencies of any MW
station. The illustration shows the 9 kHz interval zones (regions
1 and 3), and the 10 kHz interval zone (region 2).
Before using the unit, set the SPAN SELECTOR switch (on the
rear panel) to MW tuning interval (span) of your area.
To change the tuning zone:
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Set the SPAN SELECTOR switch to "50/9" for 9 kHz MW
interval (50 kHz FM interval), and "100/10" for 10 kHz MW
interval (100 kHz FM interval).
3
Press the ON/STAND-BY button whilst holding down the
button and the EQUALIZER/DEMO button.
Caution:
●
The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and CD
presets.
FM/MW (kHz)
50/9
100/10
SPAN
SELECTOR
(C
ont
inue
d)
■
Remote control
●
When inserting or removing the batteries, push them towards
the
battery terminal.
●
Installing the batteries incorrectly may cause the unit to mal-
function.
Precautions for battery use:
●
Insert the batteries according to the direction indicated in the
battery compartment.
●
Replace all old batteries with new ones at the same time.
●
Do not mix old and new batteries.
●
Remove the batteries if they are weak or if the unit will not
be used for long periods of time. This will prevent potential
damage due to battery leakage.
Caution:
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
Notes concerning use:
●
Replace the batteries if the operating distance is reduced or
if the operation becomes erratic.
●
Periodically clean the transmitter LED on the remote control
and the sensor on the main unit with a soft cloth.
●
Exposing the sensor on the main unit to strong light may in-
terfere with operation. Change the lighting or the direction of
the unit.
●
Keep the remote control away from moisture, excessive heat,
shock, and vibrations.
+
-
-
+
15
15
●
2 "AA" size bat-
teries (UM/SUM-
3
, R6
, HP
-7
o
r
similar)
0.2 m - 6 m
(8" - 20')
RE
S
E
TTI
NG
THE
MI
CRO
CO
MP
UTE
R
Reset the microcomputer under the following conditions:
●
To erase all of the stored memory contents (clock and timer
settings, and tuner and CD presets).
●
If the display is not correct.
●
If the operation is not correct.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Press the ON/STAND-BY button whilst holding down the
button and the EQUALIZER/DEMO button.
Caution:
●
The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and CD
presets.
ON/STAND-BY
EQUALIZER
/DEMO
