18
(Continued)
■
Preset tuning
You can store up to 40 stations in memory (40 stations consist-
ing of any combination of FM and AM stations you like) and
recall them at the push of a button.
To enter stations into memory:
1
Perform steps 1 - 6 in the “Tuning” section.
2
Press the MEMORY/SET button.
●
“MEMORY” and the preset channel number will flash.
3
Within 30 seconds, press the PRESET (
X
or
W
) button to
make the preset channel number flash in the display.
●
Store the stations in memory, in order, starting with pre-
set channel 1.
4
Within 30 seconds, press the MEMORY/SET button to store
that station in the selected station preset number memory.
●
If the “MEMORY” and preset number indicators go out
before the station is memorised, repeat the operation from
step 2.
5
Repeat steps 1 - 4 to set other preset stations, or to change
a preset station.
●
When a new station is stored in the selected station pre-
set number memory, the contents previously memorised
will be erased.
●
To store an RDS station in memory, perform steps 2 - 4
whilst the RDS station name is being displayed.
To recall a memorised station:
Press the PRESET (
X
or
W
) button for less than 0.5 seconds
to select the desired station.
●
The stations (preset channel number, frequency and fre-
quency band) which have been stored in memory will ap-
pear in the display in numerical order, irrespective of the
frequency bands.
Note:
When searching for a memorised station, do not press the
PRESET button for more than 0.5 seconds.
When the PRESET button is pressed for more than 0.5 sec-
onds, the unit will enter the preset memory scan mode.
Backup function:
The backup function protects all station presets for a few hours
should there be a power failure or the AC power lead is re-
moved from the AC socket.
■
Preset memory scan
The stations saved in the preset memory can be scanned au-
tomatically.
1
To scan the preset stations, press the PRESET (
X
or
W
)
button for more than 0.5 seconds.
●
The station preset number will flash and the programmed
stations will be tuned in sequentially, for 5 seconds each.
2
Press the PRESET (
X
or
W
) button again to stop the
memory scan at the desired station.
Note:
When the preset memory does not have any stations stored in
it, the preset memory scan will not function.
To erase all the contents in the preset memory:
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Press the ON/STAND-BY button whilst holding down the
TUNER (BAND) button and the X-BASS button.
●
“TUNER CL” will appear.
●
After performing this operation, all of the preset memory
information will be erased.
(Main unit operation)
http://www.usersmanualguide.com/
