30
Please check the following before calling for service:
1. Place one cup of water in a glass measuring cup in the oven and close the door securely.
Operate the oven for two minutes at HIGH 100%.
A. Does the light come on in the oven?
YES _____ NO _____
B. Does the cooling fan work?
YES _____ NO _____
(Put your hand over the top ventilation openings.)
C. Does the turntable rotate when the Turntable On/Off
YES _____ NO _____
pad is touched and TURNTABLE ON is in the display?
(It is normal for the turntable to turn in either direction when
TURNTABLE ON is in the display.)
D. Is the water in the oven warm?
YES _____ NO _____
E. Does “H” appear on the display when fan is manually turned on?
YES _____ NO _____
2. Remove the water from the oven and program:
A. Do CONV and COOK light?
YES _____ NO _____
B. After the oven shuts off, is the inside of the oven hot?
YES _____ NO _____
If “NO” is the answer to any of the above questions, please check electrical outlet, fuse and/or circuit breaker.
If either or both are not functioning properly, CONTACT YOUR NEAREST SHARP AUTHORIZED SERVICER.
A microwave oven should never be serviced by a “do-it-yourself” repair person.
NOTE:
If time appearing in the display is counting down very rapidly, check Demonstration Mode on page 26 and
cancel.
Convec
450˚F
START
Touch On
5 0 0
S E R V I C E C A L L C H E C K
C L E A N I N G A N D C A R E
Bottom tab
Louver
Oven light
Charcoal filter
Screw
Screw
Top tab
Screw
OVEN LIGHT
Remove the louver per instructions 1-4 above and
charcoal filter, if used.
5. Slide the light cover forward and lift up.
6. Remove old light bulb and replace only with an
equivalent watt bulb available from a Sharp Autho-
rized Servicer or parts distributor. Bulbs are also
available at most hardware stores or lighting centers.
DO NOT USE A BULB LARGER THAN 30 WATTS.
7. Replace the oven light cover and charcoal filter,
if used; push louver back in place (engaging both
the bottom and top tabs) and replace the louver
mounting screws.