A30092, R-880 O/M
4
2
1
3
4
5
5
9
r
e
w
u
t
y
0
i
6
780 q
o
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity. Check the unit for any damage, such as a misaligned door,
damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage,
please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP
and repaired, if necessary.
2. Accessories provided
1)
Turntable tray
2)
Roller stay
3)
Low rack
3. Since the door may become hot during cooking, you should place or mount the oven so that the bottom of
the oven is 80 cm or more above floor. You should also keep children away from the door to prevent them
burning themselves.
4. Ensure that the bottom heater is in the lowest position as shown in the OVEN DIAGRAM below (never touch
or move the bottom heater while it is hot). Then fit the turntable support to the turntable motor shaft on the
floor of the oven cavity. And place the turntable on the turntalbe support. Make sure the turntable and turntable
support are centrally located and locked together. NEVER operate the oven without the turntable support and
turntable.
5. The oven should not be installed in any area where excessive heat and steam are generated, for example,
next to a conventional oven unit.
The oven should be installed so as not to block ventillation openings.
Allow at least 40 cm on the top of the oven for free air space.
6. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 220V, 50Hz.
7. Before using top or bottom heater for the first time, operate the oven without food for 20 minutes using both
heaters. This will allow the oil that is used for rust protection to be burned off.
4) High rack
5) Combined operation manual and cookbook
OVEN DIAGRAM
1. Oven lamp
(It will light during the cooking.)
2. Top grill heater
(top heater)
3. See through door
4. Door hinges
5. Door safety latches
6. Door seals and sealing surfaces
7. Bottom grill heater
(bottom heater)
8.Oven cavity
Metal racks——High and low
The racks are for Grill, Mix,
Convection and recommended
automatic operations.
9.Turntable motor shaft
10.Ventilation openings
11.Waveguide cover
12.Door open button
13.Control panel
14.Digital readout
15.Power supply cord
16.Outer cabinet
17.Turntable
18.Turntable support
19.Ventilation slit
Warning:
The accessories will become very hot whenever the top heater, bottom heater or convection symbols are lighted
in the display and use thick oven gloves when inserting/removing the food or turntable from the oven to
PREVENT BURNS.
R880 O/M,02-15
04.3.2, 3:22 PM
4