21
R-1210
R-1211
5. Remove the two (2) screws and one (1) washer holding
the AH sensor to the exhaust duct.
6. Release the wire lead of AH sensor from the ditch of the
exhaust duct.
7. Now, the AH sensor is free.
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60
seconds.
4. Remove one (1) screw holding the right panel to the oven
cavity front face plate.
5. Release the right panel from the oven cavity front face
plate by lifting it up.
6. Disconnect the wire leads from the relays RY1 and RY2.
RIGHT PANEL ASSEMBLY AND POWER UNIT REMOVAL
7. Disconnect the connectors CN-A, CN-B, CN-C and CN-
F from the power unit.
8. Remove the right panel assembly from the oven.
9. Now, the right panel assembly is free.
10.Remove the two (2) screws holding the power unit to
the right panel.
11.Release the two (2) tabs holding the power unit to the
right panel.
12.Now, the power unit is free.
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60
seconds.
4. Release the right panel assembly, referring to items 4 to
5 of "RIGHT PANEL ASSEMBLY AND POWER UNIT
REMOVAL". ( It is not necessary to disconnect any
OVEN LAMP REMOVAL
connectors or wire leads from the power unit.
5. Release the oven lamp socket from the magnteron duct
by turning the socket counterclockwise.
6. Remove the oven lamp from the socket by turning the
oven lamp.
7. Now the oven lamp is free.
the terminal hole of the oven lamp socket with the small
flat type screw driver.
8. Now, the oven lamp socket is free.
1. Disconnect the power supply cord and remove the oven
from wall and remove outer case. (Refer to procedure of
"Removal of Oven from Wall" and "Outer case Removal")
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60
seconds.
4. Turn the lamp socket and release it from the magnetron
duct.
5. Screw the oven lamp off from the lamp socket.
6. Now, the oven lamp is free.
7. Pull the wire leads from the oven lamp socket by pushing
OVEN LAMP SOCKET REMOVAL
Oven lamp
socket
Terminal
Wire lead
Terminal hole
Flat type small
screw driver
Screw
Screws
Exhaust duct
AH sensor
Ditch
Wire lead of AH sensor
Sensor ground wire
Hole
DOOR REPLACEMENT
DOOR ASSEMBLY REMOVAL
1. Disconnect the power supply cord and remove the oven
from wall and remove outer case. (Refer to procedure of
"Removal of Oven from Wall" and "Outer case Removal")
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60
seconds.
4. Disconnect the 11-pin wire harness from the power unit.
5. Release a snap band of the 11-pin wire harness from the
hole on the base plate R.
