AR-FN7/PN1 UNPACKING AND INSTALLATION-2
<2>Install the fixing plate with the fixing screw.
6) Install the cover to the finisher.
<1>Install plate A to the position shown in the figure below, and fix it with
two fixing screws.
<2>Install plate F and plate r to their position shown in the figure below
and fix them with fixing screws (2 pcs. for each).
<3>Insert the pawl of the lower side of the front cover into the mounting
hole of plate F, and fix it with four fixing screws.
7) Install the tray.
<1>Hang two pawls of the tray on the installing section of the machine,
and fix them with two fixing screws A.
8) Connect the finisher to the paper feed desk.
<1>Remove the cover from the finisher stand.
<2>Install the connecting plate to the finisher with two fixing screws A.
<3>Install the cover to the original position.
<4>Install the finisher to the paper feed desk with two fixing screws C.
9) Check and adjust the height of the finisher.
*
Move the finisher toward the printer, and check to insure that the
guide pin of the locking plate in inserted into the connection hole of
the finisher smoothly. If not, adjust as follows.
a. When the guide pin of the locking plate is aligned with the
connection hole of the finisher:
<1>Push the finisher into the machine.
<2>If the upper and lower clearances between the printer and the
finisher are not even, remove the cap on the front/rear side of the
finisher stand with a screwdriver, remove the fixing screw (1pc for
each) of the sub cover in the front/rear side, and remove the sub
cover.
<3>Loosen the fixing screws (4 pcs.) in the adjustment section of the
finisher shown in the figure, and adjust the height adjustment screws
the front and at the back so that the clearances are even.
Front cover
Pawl
Pate A
Pate F
Pate R
Fixing screw E
Fixing screw A
Fixing screw A
Fixing screw B
Fixing screw A
1
2
2
3
Fixing screw A
Pawl
Pawl
Tray
Fixing screw C
Connecting plate
Paper feed desk
Guide pin
Connection hole
! #$! %&'(
