Menu operations
DNR (Digital Noise Reduction)
Menu Operation: A (page 12)
Produce a clearer image. (Off, High, Low)
HDMI Setup
HDMI (High-Definition Multimedia Interface) terminal
selection.
To watch an HDMI equipment image, select
“EXT6” or “EXT7” (the terminal which you are
using) from “INPUT SOURCE” menu using
b
on the remote control unit or TV.
Press
MENU
and the MENU screen displays.
Press
c
/
d
to select “Option”.
Press
a
/
b
to select “HDMI Setup”, and then
press
OK
.
• “HDMI Setup” is displayed only when “EXT6” or
“EXT7” is selected from the INPUT SOURCE menu.
MENU
[Option ... HDMI Setup]
Option
Audio Only
DNR
HDMI Setup
[Off]
Press
a
/
b
to select the desired item, and then
press
OK
.
Press
a
/
b
/
c
/
d
to select the desired setting,
and then press
OK
.
HDMI Setup
items
Selectable items
Description
Signal Type*
RGB/YCbCr 4:4:4/
YCbCr 4:2:2
Select the video signal
type from the HDMI
terminal.
Colour Matrix*
ITU601/ITU709
Select the internal
colour space
conversion method
when an RGB signal
is input.
Dynamic
Range*
Normal/Enhanced
Select the signal
amplitude range.
Usually, select
“Normal”.
Auto View
Disable/Enable
Set whether or not
to use WIDE MODE
based on signal
recognition, including
an HDMI signal.
Audio Select**
Digital/Analogue
Select “Digital” for
audio signal via the
HDMI terminal. Select
“Analogue” for audio
signal via the AUDIO
jack.
NOTE
• Refer to your external equipment operation manual for the
signal type.
• Items marked * may be greyed out (with
4
) depending on
the type of signal input from the external equipment.
• Item marked ** is only available when EXT6 is selected.
1
2
3
4
5
6
Input Select
Menu Operation: A (page 12)
For setting the signal type of external equipment.
Input source
Signal type
EXT 1
Y/C, CVBS, RGB
EXT 2
Y/C, CVBS, RGB
NOTE
•
If no (colour) image displays, try to change the other
signal type.
• Check the operation manual of the external equipment for
the signal type.
• TV, EXT3, EXT4, EXT5, EXT6 and EXT7 are not displayed in
Input Select.
• If both CVBS and RGB signals are input to EXT 1 or EXT
2 using a SCART cable, the TV may output an RGB signal
even though you have designated CVBS for the respective
terminal. This happens due to the setting of your external
equipment.
Colour System
Menu Operation: A (page 12)
You can change the colour system to one that is
compatible with the image on the screen. (AUTO, PAL,
SECAM, NTSC3.58, NTSC4.43, PAL-60)
NOTE
• Factory preset value is “AUTO”.
• If “AUTO” is selected, colour system for each channel is
automatically set. If an image does not display clearly,
select another colour system (e.g. PAL, SECAM).
• “NTSC3.58”, “NTSC4.43” and “PAL-60” cannot be
selected in TV tuner mode.
19
TV/DTV/AV only
AV only
TV/AV only
LC-26D44E-gb.indd 19
LC-26D44E-gb.indd 19
2008/02/19 10:21:33
2008/02/19 10:21:33
