Sharp Aquos LC-19A1E, Руководство по эксплуатации

Страница: 16 / 28

14
Setup menu
Auto Installation
You can run Auto Installation again, even after setting
up the preset channels.
1
Press MENU and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “Auto Installation”, and then
press OK .
If you have already set the PIN under “Child Lock”,
enter it here.
• See page 16 for setting PIN.
4
Press
a
/
b
to select “Yes”, and then press OK .
5
You can set language and country the same as in
the initial auto installation. Follow steps 1 and 2
on page 7.
Programme Setup
This section describes how to set up analogue TV
channels manually.
1
Press MENU and the MENU screen displays.
2
Press
c
/
d
to select “Setup”.
3
Press
a
/
b
to select “Programme Setup”, and
then press OK .
If you have already set the PIN under “Child Lock”,
enter it here.
• See page 16 for setting PIN.
4
Press
a
/
b
to select “Auto Search”, “Manual Adjust”,
“Sort” or “Erase Programme”, and then press OK .
Menu operations
MENU [Setup]
Setup Option
Input Label
Auto Installation
Programme Setup
Child Lock
Position
PC Setup
HDMI Audio Select
HDMI Auto View
WSS
4:3 Mode
Rotate
Lanugage
Reset
Auto Search
Manual Adjust
Sort
Erase Programme
No
Yes
Power Control menu
No Signal Off
Menu Operation: A (page 11)
When set to “Enable” the TV will automatically enter
the standby mode if there is no signal input for 15
minutes.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
NOTE
• When a TV programme finishes, this function may not
operate.
• “Disable” is the factory preset value.
MENU [Power Control]
Audio Power Control
No Signal Off
No Operation Off
Power Management
No Operation Off
Menu Operation: A (page 11)
When you select the desired time, the TV will
automatically enter the standby mode if no operation
is performed.
Power Management
Menu Operation: A (page 11)
When set, the TV will automatically enter the standby
mode.
Off: • No power management
• Factory preset value
Mode1: • If there is no signal input for 8 minutes, the TV
enters the standby mode.
• Even if you start using the PC and the signal
inputs again, the TV stays in standby mode.
• The TV turns on again by pressing
a
on the TV
or
B
on the remote control unit. (See page 7.)
Mode2: • If there is no signal input for 8 seconds, the
TV enters the standby mode.
• When you start using the PC and the signal
inputs again, the TV turns on automatically.
• The TV turns on again by pressing
a
on the TV
or
B
on the remote control unit. (See page 7.)
TV/AV only
TV only
TV only
PC only
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
NOTE
• “Disable” is the factory preset value.
30 min. / 3hr. / Disable
CAUTION
• When selecting “Reset” in the Setup menu, all menus will be reset
to the factory preset values and “Auto Installation” will activate.
Item
Item
LC-19A1E_GB_b 07.9.14, 0:57 PM 14