Sharp AN-PR1500H, Руководство по эксплуатации

Страница: 62 / 67

AN-PR1500H_EN.fm 06/3/14 TINSEA127AWZZ
62
AN-PR1500H_EN.fm 06/3/14
AN-PR1500H
TINSEA127AWZZ
References
Troubleshooting chart (continued)
Before transporting the unit
Remove the CD from the unit. Make sure there is no CD in the disc tray. Then, set the
unit to the power stand-by mode. Carrying the unit with disc left inside can damage
the unit.
Factory reset, clearing all memory
1 Press the ON/STAND-BY button to enter the power stand-by mode.
2 Whilst pressing down the button, press the ON/STAND-BY button until
“CLEAR ALL” appears.
Caution:
This operation will erase all data stored in memory including clock, timer settings,
tuner preset and CD programme.
Error indicators and warning
When you load an unplayable disc or fail to perform operations properly, the
following messages are displayed on the unit and the TV screen.
(*): Set the main unit to the stand-by mode and turn the power on again, or unplug
and plug it back in. Should the same message appear, contact your authorised
SHARP dealer or service centre.
Care of compact discs
Compact discs are fairly resistant to damage, however mistracking can occur due to
an accumulation of dirt on the disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
Do not write on either side of the disc, particularly the non-label side from which
signals are read. Do not mark this surface.
Keep your discs away from direct sunlight, heat, and excessive moisture.
Always hold the CDs by the edges. Fingerprints, dirt, or water on the CDs can
cause noise or mistracking. If a CD is dirty or does not play properly, clean it with
a soft, dry cloth, wiping straight out from the centre, along the radius.
Display Meaning
E7 Malfunction of surround circuit.
Place the unit away from noise source and plug the AC
power lead into another wall socket. (*)
ERROR The unit considers the DVD mechanism is defective. (*)
FAN LOCK The cooling fan on the rear of the unit does not run. Unplug
the AC power lead and check if foreign object get caught
around the cooling fan.
NO DISC The disc is not loaded.
NO SIGNAL The digital audio input socket is not connected properly.
Unspecified signal is received and cannot be recognised.
NO SUPPORT When copyright protected WMA file is played back.
NO
YES
Correct