AL-2051 UNPACKING AND INSTALLATION 5 - 13
8) Bend the edge of the Scanner motor lower mylar and stick
together.
9) Attach the Scanner motor lower mylar at 1 position under the
motor attachment plate on the rear side of the main unit.
Note
:
The mylar should cover the hole under the motor unit.
Attach matching the hole (the yellow mark in the diagram) and
along with the side edge (the yellow arrow in the diagram).
Disconnect the motor harness from the connector and take off
the snap band from the hole.
Press the mylar with a sharp-pointed stick or something so that
it is stuck correctly.
10) Attach the Scanner motor metal plate cushion covering the bot-
tom part of the Scanner motor lower mylar.
Note
:
The hole under the motor unit should be covered.
Attach the cushion to cover the gap between the mylar and the
metal plate (the yellow mark).
Press the cushion with a sharp-pointed stick or something to fill
the gap between the mylar and the metal plate.
11) Attach the motor connector and the snap band to the original
position.
12) Attach the Scanner UPG mylar J3 to cover the hole on the right
side of inside of the scanner.
Note
:
The mylar should cover the hole shown by the arrow in
the diagram.
Attach along with the bent part of the metal plate and align the
edge of the mylar with the line shown in the diagram (the yellow
line in the diagram).
13) Attach the Fan housing cushion to the cooling fan at the posi-
tion shown in the diagram below.
Stick together.
Stick together.
Stick the lower part of the cushion to the mylar, too.