2. List of simulation
Main code
Sub code
Content
1
1
Scanner unit operation check
5
1
Operation panel display lamps operation check
2
Fusing lamp and cooling fan operation check
3
Copy lamp operation check
6
1
Paper feed solenoids (CPFS1, CPFS2, MPFS) operation check
2
Resist solenoid (RRS) operation check
7
1
Warm-up time display and aging with JAM
6
Intermittent aging
8
1
Developing bias check
2
Main charger (Grid high output mode) check
3
Grid voltage (Grid low output mode) check
6
Transfer charger check
10
-
Toner motor operation check
14
-
Cancel of trouble other than U2
16
-
Cancel of U2 trouble
22
5
Total counter value display
12
Drum counter value display
14
P-ROM version display
21
Scanner counter value display
24
7
Drum counter clear
13
Scanner counter clear
25
1
Main motor operation check
10
Polygon motor operation check
26
1
Manual paper feed section setting
6
Destination setting
7
Machine conditions check
20
Rear edge void setting
30
CE mark application control ON/OFF setting
38
Drum life over stop cancel
39
Memory capacity setting
40
Polygon motor OFF time setting
42
Transfer ON timing control (Setting the time to transfer ON)
30
1
Paper sensor status display
43
1
Fusing temperature setting
4
Multi copy fusing temperature setting
46
1
Copy density adjustment
48
1
Front/rear scanning direction magnification ratio adjustment
50
1
Lead edge position and paper lead edge/rear edge void adjustment
10
Center offset adjustment
51
2
Resist amount adjustment
61
3
Polygon motor (HSYNC output) check
63
1
Shading check
64
1
Self print by engine only (1 by 2 mode)
(*)In the simulation mode (except for the aging mode), when the 1-digit up key is pressed while pressing the % key, it serves as the 1-digit down key.
When 10-digit up key is pressed while pressing the % key, it serves as the 10-digit down key.
AL-1000/1010
10-2
