Sharp AH-AP12JHY, Руководство по эксплуатации

Страница: 7 / 32

E-5
ENGLISH
The air purifying fi lters are packed as accessory
of this unit. During operation of the air
conditioner, the
fi lters remove dust and tobacco
smoke from the air and discharges clean air.
1
Take out the air fi lters.
1 Open the open panel.
2 Push the air filters up slightly to unlock
them.
3
Pull the air fi lters down to remove them.
2
Set the air purifying filter under the
fi lter stoppers located on the air fi lter.
3
Reinstall the air fi lters.
1 Reinstall the air fi lters in the original posi-
tions.
2
Close the open panel.
3 Push the arrow-marked of the panel fi rmly
to lock it in place.
Precautions:
• The fi lters are sealed in a plastic bag to keep
their dust collection effect.
Do not open the bag until using the filters.
(Otherwise the fi lters life may get shorter.)
• Do not expose the filters to direct sunlight.
(Otherwise they may deteriorate.)
TIPS ON SAVING ENERGY
Below are some simple ways to save energy
when you use your air conditioner.
SET THE CORRECT TEMPERATURE
• Setting the thermostat 1°C higher than the
desired temperature in the COOL mode will save
approximately 10 percent in power consumption.
• Setting the temperature lower than necessary
during cooling operation will result in increased
power consumption.
BLOCK DIRECT SUNLIGHT AND PREVENT
DRAFTS
• Blocking direct sunlight during cooling operation
will reduce power consumption.
• Close the windows and doors during cooling
operation.
SET PROPER AIR FLOW DIRECTION TO OBTAIN
THE BEST AIR CIRCULATION
KEEP FILTER CLEAN TO ENSURE THE MOST
EFFICIENT OPERATION
MAKE MOST OF THE TIMER OFF FUNCTION
DISCONNECT THE POWER CORD WHEN THE
UNIT IS NOT USED FOR AN EXTENDED PERIOD
OF TIME
• The indoor unit still consumes a small amount of
power when it is not operating.
AUXILIARY MODE
Use this mode when the remote control is not
available.
TO TURN ON
Lift the open panel of the indoor unit and press
the AUX. button.
• The red OPERATION lamp ( ) on the unit will
light and the unit will start operating in the AUTO
mode.
• The fan speed and temperature setting are set to
AUTO.
TO TURN OFF
Press the AUX. button again.
• The red OPERATION lamp ( ) on the unit will
turn off.
NOTE:
• If the AUX. button is pressed during normal
operation, the unit will turn off.
SETTING AIR PURIFYING
FILTER
Filter stopper
Air purifying fi lter
Air fi lter
3
2
1
1
3
2
AUX