18
Front panel
back view
(3)
(1)
(2)
6
Slide the chassis back into the
cabinet. (Fig. 11)
Replace the front panel. (Fig.12)
Slide the crank shaft into the
opening of the louver link at the
back of the front panel. (Fig.13)
(4)
Fig.11
Chassis
Angle
Hole
Cabinet
Louver link
Crank shaft
Front panel
Fig.12
Fig.13
Grille
Fig.15
Front panel
Secure the chassis to the cabinet
using the screw and angle removed
in Step 2. Push the angle into the
gap between the chassis and the
cabinet. Slide the angle to the right
until the holes meet, and screw it
on to the chassis. (Fig.11)
Remove the grille from the front
panel. (Fig.14)
At this step, make sure the cabinet is
inclined approximately 1cm (3/8") to
the back (Fig.10).
If the cabinet is not properly inclined,
the water collected in the bottom tray
during operation will not drain properly
and may flow into the room where the
air conditioner is installed.
(3)
Attach the bottom gasket to the
gap between the mounting frame
and the unit to seal outside air.
(Fig.9)
WARNING:
cabinet
mounting
frame
incline backwards about 1cm
(3/8")
INSTALLATION
Fig.10
Air filter
Front panel
Fig.14
1
2
1
2
Remove the air filter from the front
panel. (Fig.15)
Secure the front panel with one
short screw(1.2cm/0.5") and
replace the air filter and the grille.
(5)
Scratching screw for grounding.
Serration
http://www.usersmanualguide.com/
