Each time you press
SURROUND
, the mode changes
between ON , ON and OFF.
OFF : Produces normal sound.
ON
: Setting to this mode during stereo signal reception
produces a spacious sound, making the most of the
speakers’ performance.
ON
: Setting to this mode during monaural signal reception
creates monaural sound that is similar
to stereophonic sound.
Surround sound
Produces a virtual surround sound from the TV’s speakers.
E11
USEFUL FEATURES (Continued)
TV / Video selection
Switches between TV broadcasts and AV input programmes.
• Each time you press the
TV/VIDEO
, the input switches between
AV and TV programme.
TV/VIDEO
TV
0
4
7
2
8
3
6
9
CH
CH
1
5
MENU
SURROUND
LANGUAGE
NORMAL
SURROUND
TV/VIDEO
SURROUND
ON
SURROUND
OFF
SURROUND
ON
25
SECAM
D/K
AV
This unit is equipped with a microprocessor. Its performance could be adversely affected by external
electrical noise or interference. If this should happen, unplug the unit and plug it in again after a few
minutes.
The following problems do not always indicate a hardware failure. Therefore, please use the
troubleshooting guide below before calling for repair service.
If, after following the guide none of the remedies work, unplug the TV set and call for service.
E12
TROUBLESHOOTING
Quick
Service
Check List
Try a new channel to check for possible station
trouble.
TV not plugged in.
Outlet power OFF.
Antenna not connected to terminal at the back
of the TV set.
If outside antenna is used, check for broken
wires.
Check for local interference.
Adjust COLOUR control.
Check batteries in the remote control.
Try fine tuning to correct.
Contrast setting in picture mode might be all
the way to the minus side. Press the
NORMAL
button on the remote control to
correct.
Increase the volume.
Problems
Remote control does not work.
Bars on screen.
Picture distorted.
Picture rolls vertically.
No colour.
Poor reception on some channels.
Picture weak.
Picture lines or streaks.
Picture ghosting.
Picture blurred.
Sound OK, picture poor.
Picture OK, sound poor.
No picture or sound.
Possible Causes/Remedies
POWER
switch of TV not ON.
Turn OFF using the
POWER
switch,
then turn ON again after a minute.
•
SURROUND
mode is not working if BALANCE in the SOUND menu is adjusted and not in centre (0).
Please see
E8
Sound adjustment.
21L-FG1RU[EN]
3/8/06, 2:03 PM
7
