190TW8 TV
Electronic Instruction
17
F/W upload instruction
Configuration and procedure(ISP tool)
Purpose and Scope
This document contains introduction the user update firmware
environment and run it on MTK tool.
Prepare to update firmware using ISP board
1. Connection ISP board between PC side and TV side.
* Using USB cable connect between ISP board and PC side, see
figure 1.
* Connect ISP board and TV set by VGA cable, see figure 1
Figure 1
2. How to update firmware:
* Make sure ISP board and TV set are connection.
* Enter factory mode:
A. Use remote control, press “ MENU” key to show use OSD menu
and then key “5588”.
B. Factory mode OSD display when setting OK.
* Executing MTK update tool
MTK tool
* Select com Port and Baud rate
* Press Reset icon
The error message will show on screen when communicate NG.
* Press lightning icon to enter update page.
* Press Browse to choose firmware file.
* Press upgrade to update firmware.
If upgrade fail please to lower Baud rate, then AC power off and
turn on again. Then follow update flow to upgrade firmware again.
Figure 2 Update page
* When update finish, then AC power off and turn on again,
see figure 3.
Figure 3. Finish update firmware illustration
Содержание 190TW8FB
