SHARKS SH 1600W, Инструкция по эксплуатации и обслуживанию

Страница: 46 / 53

420 774 335 397 www.sharks-shop.cz
Stránka 46
●
Depth gauge
The depth gauge 9 is convenient for drilling holes of uniform depth.
note: The depth gauge cannot be used at the position where the depth gauge strikes against the tool
body.
● Bit grease
Coat the bit shank head before hand with a small amount of bit grease )about 0.5-1g; 0.02-0.04 oz).
This chuck lubrication assures smooth action and longer service life.
● Changing the bit
Before any work on the tool itself, pull the mains plug.
With the SDS-plus tool holder, simpler and easier tool changing is possible without additional aides.
The dust cap 1 largely orevents the entry of drilling dust into the ool holder during operation. When
inserting the tool, take care that the dust cap 1 is not damaged.
A damaged dust protection cap should be changedimmediately. We remmomend having this carried
out by an after-sales service.
● Inserting the bit (see fig.8)
Clean and lightly grease the shank end of the tool. Push
back the locking sleeve 2 and insert the bit in a twisting
mannet into the tool holder until it locks itself. After
installing, always make sure that the bit is securely held in
place by trying to pull it out.