AU
02 8 8 01 76 6 6 •
sharkclean .com . au
NZ
0 8 0 0 112 6 60 •
sharkclean .co.nz
MAINTAINING YOUR VACUUM
TROUBLESHOOTING (CONTINUED FROM PREVIOUS PAGE)
NOTE:
If vacuum still does not operate properly, contact customer support.
LED indicator error codes:
ERROR CODE
WHAT IT MEANS:
WHAT TO DO:
All 3 LED indicator lights
are blinking
The battery is not
properly inserted in
the vacuum cleaner.
If possible, try another battery. Insert the battery until
it clicks, sliding it into the vacuum cleaner body. If the
problem persists, please contact Customer Service.
LEDs 1 and 3 are blinking
Motor is
overheating.
Allow the vacuum cleaner and battery to cool to
room temperature for about 45 minutes.
LEDs 1 and 2 are blinking
Overcurrent or
short.
Turn off the power, remove any clogging dust, and
then turn on the power again.
Top LED is blinking
Battery needs to
be charged.
Place the vacuum cleaner on the charging dock to
charge it.
LED 2 is blinking
Overspeed.
Turn off the power, remove any clogs, and then turn
on the power again. If the problem persists, please
contact Customer Service.
LED 3 is blinking
Communication.
Contact Customer Service.
LEDs 2 and 3 are blinking
The charging dock
may be defective.
Please use the included genuine charging dock. If the
problem persists, please contact Customer Service.
LEDs 1 and 3 are blinking
alternately with LED 2
/
The filter may
not be installed
correctly.
Tilt the filter housing up and remove the fabric filter
by pulling on the wire handle. Reinstall the filter
by sliding it back into the housing, then press the
housing firmly into place. Close the dust cup door,
pressing it until it clicks into place. If the problem
persists, please contact Customer Service.
REPLACEMENT PARTS AND ADDITIONAL ACCESSORIES
A
Duster Crevice Tool
B
Upholstery Tool
C
Motorised Hand Tool
D
Replacement Battery
E
Floor Nozzle Tool
D
B
E
A
NOTE:
To order replacement parts and additional accessories, visit
sharkclean.com.au
or
sharkclean.co.nz
C
