Shark S4601 Series, Руководство пользователя

Страница: 9 / 16

8 www.sharkclean.com
The Shark
®
Blast & Scrub Steam Pocket
®
Mop has 3 unique steam settings so you can use the right amount of
steam for the cleaning task at hand. See below for tips on when to use each setting.
SETTING IDEAL FOR THESE SURFACES RECOMMENDED USAGE
LO
Laminate
Hardwood
Marble
Cleaning delicate surfaces
Light cleaning and dusting
Loosening and lifting light dirt
Sanitizing floors
MED
Hardwood
Marble
Tile
Stone
Cleaning most surfaces and large areas
Basic, everyday cleaning
Removing spots and smaller messes
Cleaning moderate- and heavy-traffic areas
Sanitizing floors
HI
Hardwood
Marble
Tile
Stone
Deep-cleaning and cleaning hard-to-clean surfaces
Tough cleaning and removing stuck-on messes and stains
Deep-cleaning heavy-traffic areas
Cutting through heavy dirt and grime
Sanitizing floors
SCRUB BLAST
LO
MED
HI
To engage the Scrub Blast Mode, slide the Engage Scrubber/Release Head Button down until
you hear a click. The Stain Scrubber will automatically pop in to position. Lift the Mop body off
the Mop Head and place the Stain Scrubber on the floor to start scrubbing. You can select you
preferred level of steam. Use the
LO setting for low-moisture, MED for more dried-on messes,
and HI for stubborn, stuck-on stains.
TO SANITIZE* WITH THE RECTANGLE MOP HEAD
1
Start with a clean Pocket Pad.
2
Plug in the unit and press the Steam Control Button to select either the LO , MED or HI Setting.
3
Wait 30 seconds for the unit to begin producing steam.
4
Start mopping on an appropriate sealed hard-floor surface with a forward and backward motion. After three minutes,
your unit is ready to be used to sanitize.
5
Using a forward and backward motion, move the unit over the area you seek to sanitize. Repeat at least 15 times.
* Sanitization studies were conducted under controlled test conditions. Household conditions and results may vary.
With Rectangle Mop Head only. Not in Blast & Scrub mode.