Shark Rotator NV680ANZ, Руководство пользователя

Страница: 6 / 9

9 10 N Z : 0 8 0 0 0 0 2 9 9 9 A U S T: 18 0 0 8 9 0 8 4 0
TROUBLE-SHOOTING GUIDE
Vacuum is not picking up dirt. No suction or light suction • Check filters to see if they need cleaning� Follow instructions for rinsing and drying the filters before re-inserting back
into the vacuum�
• Dust cup may be full; empty dust cup�
• Check hose, hose connections, nozzles, and accessories for blockages; clear blockages if required�
• Remove any string, carpet fibers or hair that may be wrapped around the brushroll�
Vacuum lifts area rugs • Turn off the unit to disengage the brushroll and restart with the POWER button for suction only cleaning�
• Suction is powerful� Take care when vacuuming area rugs or rugs with delicately sewn edges�
• Turn off the unit and disengage the area rug from the brushroll and restart the unit�
Brush roll does not spin • If brush roll indicator light on the floor nozzle turns red, the brush roll has stopped spinning� Immediately turn off and
unplug vacuum, disconnect the nozzle and remove blockage before reconnecting and turning vacuum back on�
• Pull the handle toward you and release the floor nozzle to disengage the auto-off feature�
• Make sure that the carpet height selector is not on the HARD FLOOR setting�
• Immediately turn off and unplug vacuum, disconnect the nozzle and remove blockage before reconnecting and turning vacuum
back on�
Vacuum turns off on its own or indicator light flashes red • This vacuum cleaner is equipped with a motor protective thermostat� If for some reason your vacuum overheats, the
thermostat will automatically turn the suction motor off� Should this occur, perform the following steps to restart the
thermostat:
1� Turn the unit off�
2� Unplug the vacuum�
3� Empty the dust cup and clean filters (see page previous page)
4� Check for blockages in hose, accessories and inlet openings�
5� Allow the unit to cool for a minimum of 45 minutes�
6� Plug in the vacuum�
7� Restart the unit by turning the power on�
Note: If vacuum still does not start, contact Customer Service at: AUST: 1800 890 840 or NZ: 0800 002 999�
MAINTENANCE
To keep your vacuum’s suction power optimal, follow these instructions.
Make sure unit is off and cord unplugged.
CHECK FOR BLOCKAGES
1 Use a coin to unlock the 3 locks on the
bottom of the floor nozzle�
2 A portion of the base is removable to
allow for better access to the brush roll
and exposure to the airway� Shine a
flashlight from the bottom to check for
possible blockage in the airway�
3 Remove any string, carpet fibers or
hair that may be wrapped around
the brush roll� There is a groove on
the brush bar that allows a pair of
scissors to cut across it to loosen
up the debris�
4 To reassemble, replace base by
lining it up along the front of the
nozzle� Push down to snap into
place� Lock the 3 locks�
STEP 1 STEP 2 STEP 4 STEP 3