9
10
0 8 0 0 8 6 2 0 4 5 3
w w w.
shar kclean .eu
RECOMMENDED FILTER CLEANING SCHEDULE:
Pre-motor Filter Kit (Foam & Felt):
XFF680
Every 3 months
Post Motor Filter:
XHF680
Every year
EMPTY THE DUST CUP
1
Pull up on the dust cup release latch and lift the dust cup
off the pod�
2
Holding the dust cup over a garbage bag or can, press the
bottom empty release latch�
3
Press the top dust cup release latch to access the dust
screen and remove built-up debris as required�
CLEAN THE FILTERS
1
With the dust cup removed, remove and rinse the foam
and felt filters every 3 months� Let air dry completely
before replacing� Hand wash only� Tap loose dirt off
filters between washes as needed�
2
Once a year open the filter grill and remove and
rinse the HEPA filter� Let air dry completely before
replacing� Hand wash only�
WARNING: DO NOT PICK UP FIREPLACE ASH
OR DRYWALL DUST.
MAINTENANCE
To keep your vacuum’s suction power optimal, follow these instructions.
Make sure unit is off and cord unplugged.
IMPORTANT: Allow ALL filters to dry completely before replacing into the vacuum.
STEP 1
STEP 2
STEP 3
HEPA
FELT FILTER
FOAM FILTER
FILTER FRAME
MAINTENANCE
To keep your vacuum’s suction power optimal, follow these instructions.
Make sure unit is off and cord unplugged.
CHECK FOR BLOCKAGES
1
Use a coin to unlock the 3 locks on the
bottom of the floor nozzle�
2
A portion of the base is removable to
allow for better access to the brush roll
and exposure to the airway� Shine a
flashlight from the bottom to check for
possible blockage in the airway�
3
Remove any string, carpet fibers or
hair that may be wrapped around
the brush roll� There is a groove on
the brush bar that allows a pair of
scissors to cut across it to loosen
up the debris�
4
To reassemble, replace base by
lining it up along the front of the
nozzle� Push down to snap into
place� Lock the 3 locks�
STEP 1
STEP 2
STEP 4
STEP 3
