sharkclean .com
sharkclean .com
MAINTENANCE
CHECKING FOR BLOCKAGES
MAINTENANCE
Remove the wand from the handheld vacuum and
check all dust cup intake openings.
Detach the wand. To open the brushroll garage, slide
both release buttons on the floor nozzle away from
you, toward the back of the nozzle, then lift off the lid.
Tilt back the neck of the nozzle and check openings
for blockages. To close the brushroll garage, insert
the 3 tabs on top of lid into the 3 slots in the nozzle,
then push down firmly on both sides of the lid until it
clicks securely into place.
Detach the wand and check it for blockages.
NOZZLE MAINTENANCE
NOTE:
With normal use, you may need to perform routine maintenance of your Soft Roller.
NOTE:
If the brushroll indicator light is green and the headlights are flashing, check again that both sides of the lid are locked
in place.
CLEANING THE SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue cleaning, using Carpet mode on a bare floor surface, a
low-pile carpet, or a small area rug. This will allow the self-cleaning brushroll to remove the hair wrap and send
it to the dust cup.
If some fibers remain wrapped around the brushroll after continued use, open the brushroll garage to remove
them.
1
To open the brushroll garage, slide both release buttons on the floor nozzle away from you, toward the
back of the nozzle, then lift off the lid.
2
Clear away any objects or debris.
3
To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then push down
on both sides of lid until it clicks securely into place.
If Brushroll Indicator Light is green and headlights
are flashing, check again that both sides of lid are locked in place.
CLEANING THE SOFT ROLLER
1
To remove Soft Roller from nozzle, first open the brushroll garage, then pull the Soft Roller out by the tab.
2
Tap loose debris off the Soft Roller. Use a dry towel to wipe the Soft Roller clean, and to remove any debris
caught in the teeth behind the Soft Roller.
3
Hand wash the Soft Roller as needed. Use only water, and let air-dry completely for at least 24 hours.
4
Reinsert the Soft Roller and close the brushroll garage by inserting the 3 tabs on top of the lid into the 3 slots
in the nozzle. Then push down on both sides of the lid until it clicks securely into place. If Brushroll Indicator
Light is green and headlights are flashing, check again that both sides of the lid are locked in place.
1
2
CHECK HANDHELD
CHECK FLOOR NOZZLE
CHECK WAND
