12
TOLL FREE: 1-800-798-7398
Maintenance
Resetting the Motor Thermostat
Your
Shark
®
Navigator™
Professional Vacuum is equipped
with a protective Motor Thermostat.
If the motor should overheat, the
thermostat shuts off the power.
To reset the Motor Thermostat:
Move the Power Button to the
“
O
”
– Off
position.
Unplug the vacuum.
Check for clogged hose or filter;
unclog hose and replace filter.
Refer to
Checking for Blockages
on page 11.
Wait 45 minutes for vacuum to cool;
then plug in the vacuum.
Turn the Power Switch to the
“
I
”
– On
position to start the
vacuum.
Note: If vacuum still does not start,
contact Customer Service at:
1-800-798-7398.
1
Cleaning the Pet Hair Power
Brush -
Slide locking latch (
A
) forward.
Gently tilt brush housing upward
to open.
IMPORTANT: DO NOT
force; it
will not open all the way.
Remove debris from turbine
wheel and air passage.
A
Ordering Replacement Parts
To order additional parts and
accessories, go to
www.sharkclean.com
or call
1-800-798-7398
.
PART
PART NO.
Super Stretch Hose
162FFJ
Dusting Brush &
Crevice Tool
170FFJ
Foam & Felt Filters
XFF80
Hepa Filter
XHF80
Turbo brush
174FFJ
Cleaning Wand
166FFJ
16"Crevice Tool
167FFJ
CLEANING THE MOTORIZED
FLOOR BRUSH
When your motorized floor brush
needs cleaning or locks onto an
object, it automatically shuts
down to prevent damage to your
lifetime belt. The indicator light
will illuminate red warning you
to turn off the vacuum and clear
blockage immediately. The light will
reset itself once blockage has been
cleared and power has been cycled
on/off or vacuum has been locked in
the upright position.
1
Detach the motorized floor
brush from the detachable
canister.
2
Inspect the opening underneath
and the rotating brush. If a
build-up of debris is present,
remove it. Carefully cut
anything wound around the
rotating brush with scissors.
Avoid damaging or cutting the
bristles.
Rotating
Brush
NVC80C_26_IB_E_F_111130_4.indd 12
11-11-30 10:00 AM
