Shark NP317W, Руководство пользователя

Страница: 7 / 12

7 www.sharkclean.com
CLEANING THE POST-MOTOR FILTER
1 Remove the filter cover from the vacuum by pulling
up on the tab and pulling the cover away from the
vacuum. Then remove the post-motor filter.
2 Turn the filter over so that the dirty side is
on the bottom and vigorously tap it clean
against a trash bin.
3 Wash the filter running, lukewarm water
with the dirty side face down until the
water runs clear.
4 Allow the Post-Motor filter to air-dry completely
before replacing.
5 Once the Post-Motor filter is dry, replace it back into
the vacuum.
6 Replace the cover by inserting the two tabs into the
holes at the top and then swinging the cover down
until it clicks into place.
CLEANING THE PRE-MOTOR FILTERS
1 Remove the Dust Cup.
2 Remove the Pre-Motor filters out from the top of
the motor base.
3 Rinse the filters thoroughly under running,
lukewarm water until the water runs clear.
4 Squeeze out excess water and let air-dry
completely before replacing.
5
Place the felt filter in first, then the foam filter.
6 Replace the Dust Cup.
DO NOT
operate the vacuum without ALL the filters in place.
DO NOT operate the vacuum with WET filters.
DO NOT put any of the filters in the washing machine or dishwasher.
DO NOT use a hair dryer or other heating methods to dry.
NOTE:
The material in the filters will discolor over time. This is NORMAL and will not affect the performance of the filters
IMPORTANT: Loss of Suction may occur if foam/felt filter is not cleaned every month. Rinse and allow
to air dry completely. Tap loose dirt from foam filter as needed in between washing. Foam filter may appear
dirty after use—this is normal.
COMPONENT MAINTENANCE SCHEDULE
Rinse and air dry every month under normal use.
Empty each time you vacuum.
Pre-Motor Foam & Felt Filter
(Part # XFFP317)
Dust Cup
Clean once every 12 months under normal use. Post-Motor Filter
(Part # XHFP317)
1
2
3
Post-Motor
Filter
Pre-Motor
Foam Filter
Felt Filter