9
www.sharkclean.com
COMPONENT
MAINTENANCE SCHEDULE
Rinse and air dry every month under normal use.
Empty each time you vacuum.
Pre-Motor Foam Filter
Dust Cup
Rinse and air dry every month under normal use.
Pre-Motor Felt Filter
Clean once a year under normal use.
Post-Motor HEPA Filter
1
2
3
4
To clean the pre-motor filters:
1
Remove the dust cup.
2
Pull the 2 filters out from the top of the motor
base.
3
Rinse the filters thoroughly in lukewarm water until
the water runs clear.
DO NOT
put the filters in the washing machine or
dishwasher.
NOTE:
The material in the filters will discolor
over time. This is NORMAL and will not affect the
performance of the filters.
4
Squeeze out excess water and let air-dry for at
least 24 hours before replacing. Do not use a hair
dryer or other heating methods to dry.
5
Place the felt filter in first, then the foam filter.
6
Replace the dust cup.
To clean the post-motor HEPA filter:
1
Remove the filter cover from the front of the
vacuum by pulling up on the tab and pulling the
cover away from the vacuum.
2
Take out the HEPA filter by pulling it straight out.
3
Turn the HEPA filter over so that the dirty side is on
the bottom and vigorously tap it clean against a
garbage can to remove any dust.
4
Wash the HEPA filter under the tap using lukewarm
water with the dirty side face down until the water
runs clear.
DO NOT
put the HEPA filter in the washing
machine or dishwasher.
NOTE:
The material in the filter will discolor over
time. This is NORMAL and will not affect the
performance of the filter.
5
Allow the HEPA filter to air dry for 24 hours. Do
not use a hair dryer or other heating methods to
dry.
6
Once the HEPA filter is dry, replace it back into the
vacuum.
7
Replace the cover by inserting the two tabs into
the holes at the bottom and then swinging the
cover up until it clicks into place.
DO NOT
operate the vacuum without ALL the filters in place.
DO NOT
operate the vacuum with WET filters.
Pre-Motor
Foam Filter
Felt Filter
Post Motor
HEPA Filter
IMPORTANT: Loss of Suction may
occur
if foam filter is not cleaned
every month. Rinse and allow to air dry
completely. Also, tap loose dirt off filter
between washes as needed.
Foam filters may appear dirty after use -
this is normal.
Содержание Navigator NV60
Страница 1: ...Owner s Guide www sharkclean com NV60 ...
