TOLL FREE: 1-800-798-7398
18
CLEANING THE MOTORIZED FLOOR BRUSH
When your motorized floor brush needs cleaning or locks
onto an object, it automatically shuts down to prevent
damage to your lifetime belt. The indicator light will
illuminate red warning you to turn off the vacuum and
clear blockage immediately. The light will reset itself
once blockage has been cleared and power has been
cycled on/off or vacuum has been locked in the upright
position.
1
Detach the motorized floor brush from the
detachable canister.
2
Inspect the opening underneath and the rotating
brush. If a build-up of debris is present, remove it.
Carefully cut anything wound around the rotating
brush with scissors. Avoid damaging or cutting the
bristles.
(Fig. 25)
Maintenance - cont’d
Rotating
Brush
Fig. 25
Fig. 23
Fig. 22
Fig. 24
CLEANING THE POST-MOTOR HEPA FILTER
1
Remove the filter cover from the front of the vacuum
by pulling up on the tab and pulling the cover away
from the vacuum.
(Fig. 22)
2
Take out the HEPA filter by pulling it straight out.
3
Turn the filter over so that the dirty side is on the
bottom and vigorously tap it clean against a garbage
can to remove any dust.
(Fig. 23)
4
Wash the filter under the tap using lukewarm
water with the dirty side face down until the water
runs clear.
(Fig. 24)
DO NOT
put the filter in the washing machine
or dishwasher.
NOTE:
The material in the filter will discolor over
time. This is NORMAL and will not affect the
performance of the filter.
5
Allow the filter to air dry for 24 hours. Do not use a
hair dryer or other heating methods to dry.
6
Once the HEPA filter is dry, replace it back into
the vacuum.
7
Replace the cover by inserting the two tabs into the
holes at the top and then swinging the cover down
until it clicks into place.
CLEANING THE PET POWER BRUSH
1
Slide the locking latch
(a)
forward and tilt the bottom
cover upward to remove.
(Fig. 26)
2
Carefully remove any blockage or debris and cut
away any build-up of hair or string wrapped around
the rotating bristle brush with scissors.
3
To reassemble, insert the tabs on the front edge of
the bottom cover into the matching holes in the top
half and tilt it back down until it clicks into place.
(Fig. 27)
Fig. 27
Fig. 26
a
Содержание Navigator Lift-Away NV351
Страница 1: ...www sharkclean com Owner s guide Guide du propriétaire Guía del usuario NV351 NV352 NV353 ...
Страница 46: ...46 1 800 798 7398 Notes Remarques Notas ...
Страница 47: ...47 www sharkclean com English Notes Remarques Notas ...
Страница 48: ...48 Notes Remarques Notas 1 800 798 7398 ...
