sharkclean.com
sharkclean .com
FLOOR NOZZLE
MAINTAINING YOUR VACUUM
CLEANING SOFT ROLLER
FLOOR NOZZLE
If any hair is wrapped around the brushrolls, continue cleaning using the Carpet setting on a bare floor
surface, a low-pile carpet, or a small area rug. If some fibers remain wrapped around the brushrolls after
continued use, carefully remove them. If you run over a hard or sharp object or notice a change in noise
while vacuuming, check the floor nozzle for blockages. (See the Checking for Blockages in the Floor Nozzle
section.)
MAINTAINING YOUR VACUUM
CHECKING FOR BLOCKAGES
Checking for Blockages in the Handheld Vacuum:
1.
Turn off vacuum.
2.
Remove the handheld vacuum from the wand.
3.
Check all intake openings on the dust cup and remove
any debris or blockage.
Checking for Blockages in the Wand:
Standard Wand:
1.
Turn off vacuum.
2.
Remove the handheld
vacuum and floor nozzle.
3.
Look through wand to
check for any blockages.
4.
Clear away debris and
blockages.
MultiFLEX® Wand:
1.
Turn off vacuum.
2.
Remove the handheld
vacuum and floor nozzle
from the wand.
3.
Check the
Clog Access
Hose
on the MultiFLEX
section of the wand by
pinching the tabs on both
sides of the hose and
lifting the hose out.
4.
Clear any debris and
blockages.
Checking for Blockages in the Floor Nozzle:
1.
Turn off vacuum.
2.
Detach the wand.
3.
Use the edge of a coin to open the three locks on the
bottom of the floor nozzle.
4.
Remove the cover and tilt back the neck of the floor
nozzle.
5.
Check the opening and remove any debris.
6.
Replace the cover by sliding the inserts into the slots, then
pressing down firmly on all sides. Turn the locks clockwise
to close, until they click securely into place.
1
To remove the Soft Roller from the nozzle, turn off the
vacuum and detach the wand. Use the edge of a coin to
open the lock on the bottom of the floor nozzle. Pull the
Soft Roller out by the tab.
2
Tap loose debris off the Soft Roller. Use a dry towel to wipe
the Soft Roller clean and to remove any debris caught in the
teeth behind the Soft Roller.
3
Hand wash the Soft Roller as needed. Use only water, and let
air-dry completely, which should take at least 24-48 hours.
4
Reinsert Soft Roller until you feel it click into place.
CLEANING THE SENSORS
IQ logos-
both sides
Fig. 2
CLEAN SENSE IQ SENSORS
Hand Vacuum Display Panel
Dust cup
Air path
Fig. 1
Battery
Make sure to clean the sensors
inside the hand vacuum regularly,
as hair and other debris may build
up and obstruct them. If the sensors
are partially obstructed, Clean
Sense IQ mode will not adjust
suction levels as expected. If the sensors are
completely obstructed, the F0 error code will
appear and the Clean Sense IQ icon will flash
on the hand vacuum display panel.
To clean the sensors:
1.
Turn off power and remove the hand vacuum.
2.
Locate the sensors inside the nozzle of
the hand vacuum. The sensors are on the
interior walls of the nozzle, about 3 inches
down the air path, aligned with the IQ
logos (Fig.2) on the exterior.
3.
Gently wipe the sensors with a microfiber
cloth and remove all hair and debris.
4.
Turn on power and verify that the unit is
functioning normally.
