sharkclean .com
sharkclean .com
CHECKING FOR BLOCKAGES
MAINTENANCE
Remove the handheld vacuum from the wand and
check all dust cup intake openings for debris or
blockages.
Detach the wand from the floor nozzle and set aside.
Tilt the floor nozzle tube back and check openings
for blockages.
Remove any blockages or debris from the floor nozzle
debris intake.
(See Floor Nozzle Maintenance section to check
underneath the nozzle.).
Detach the wand and check it for blockages.
CHECK HANDHELD
CHECK WAND
CHECK FLOOR NOZZLE
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Do not use soap. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electronic parts.
If there is an unusual loud noise and loss of suction. Check for blockages in your vacuum.
MAINTENANCE
CLEANING FILTERS
IMPORTANT:
Unplug the vacuum before performing any maintenance.
PRE-MOTOR FILTERS
Replacement Pre-Motor Filter Kit
XFFKHZ2000
Replacement Post-Motor Filter
XPMFHZ2000
REPLACEMENT FILTERS
With the dust cup detached, press the Filter
Access buttons on both sides of the back of the
dust cup, then pull out the filter housing. Pull the
foam filter out of the housing, then lift out the felt
filter by the pull tab.
The
Pre-Motor Filters
should be washed once a
month.
Remove the filter cover on the top of the handheld
vacuum to access the post-motor filter. To insert
the filter cover, lead with the bottom and press the
top into the handheld until it clicks into place.
The
Post-Motor Filter
should be washed once
every 12 months.
POST-MOTOR FILTER
NOTE:
The pre-motor filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
