USING YOUR 3-IN-1 CLEANER
POWER
HARD FLOOR MODE
AREA RUG MODE
MAINTAINING YOUR 3-IN-1 CLEANER
RECOMMENDED AFTER EVERY USE
1.
Place the unit on the Storage Tray. The Self-Clean
mode icon located on the top of the main body
will pulse.
2.
Empty the
Dirty Water Tank
and make sure the
clean solution tank is at least half full.
3.
Press the
Power Button
to start the self-clean
cycle. The icon will illuminate for the full 2-minute
duration of the cycle.
4. DO NOT
remove the unit from the tray during the
self-cleaning cycle. The icon will turn off when the
cycle is complete.
5.
Empty the dirty water tank.
Press and release the
Power
button on the handle
to turn on power. To turn off power, press the
button again.
Use Hard Floor mode for powerful cleaning on bare
floors. To activate Hard Floor mode, turn on the unit
and tilt the handle back.
To clean area rugs, press the Area Rug icon on top
of the handle. The Area Rug light on the main body
will illuminate. To turn off Area Rug mode, press the
button again.
CONTROLS
CLEANING MODES
NOTE:
Make sure the clean solution tank is at least half full and that the dirty water tank is empty before running the self-
cleaning cycle.
NOTE:
To prevent leakage, DO NOT place the main body on the floor. The nozzle should always be kept flat on the floor.
NOTE:
If your floors are cloudy, streaky, or spotty after cleaning, it may be due to accumulated soap or grease residue. The
floor may require several cleanings with the Hydrovac.
NOTE:
If you encounter a difficult stain, use Area Rug Mode for improved stain cleaning.
NOTE:
If you encounter a stubborn odor on your floor or area rug, continue to clean in Area Rug mode until the odor is gone.
SELF-CLEAN CYCLE
The self-clean cycle automatically cleans the system and the brushroll.
Recommended after every use
sharkclean .com
sharkclean .com
