USING YOUR 3-IN-1 CLEANER
To use, unwrap the power cord from the back of the unit. Plug the prongs in to a safe outlet.
Make sure the prongs are not wet before plugging into an outlet. When you are done cleaning,
unplug the cord and wrap it around the cord-wrap hooks.
NOTE:
To remove the handle, press the release button located on the back of the unit with a thin tool while pulling up on the
handle.
NOTE:
When assembling your HydroVac, there may be a little water in or around the water tanks. This is because we test all
our HydroVacs before you buy them to ensure the highest quality.
ASSEMBLY
Cord Wrap
Storage Tray
(Click)
Handle
Pole
Main Body
1.
Align the
Pole
with the opening in the
Main Body
and insert firmly until it clicks
into place.
2.
Place the
Storage Tray
on the floor near
a wall outlet. Place the 3-in-1 Cleaner on
the tray.
USING YOUR 3-IN-1 CLEANER
Press the release button and lift off the
Clean Solution Tank
.
NOTE:
Only use Shark HydroVac Multi-Surface Concentrate, Shark HydroVac Disinfectant, and water with this product.
NOTE:
If the clean solution tank is empty, the unit may make a pumping sound. This is normal. Refill the clean solution tank to
continue.
NOTE:
Be sure to not overfill the Clean Solution Tank with more HydroVac Multi Surface Concentrate than instructed, as this
may cause streaking.
NOTE:
The 3-in-1 Cleaner will not run without sufficient water supply in the clean solution tank.
FILLING THE CLEAN SOLUTION TANK
REMOVE THE CLEAN SOLUTION TANK
1
FILL THE CLEAN SOLUTION TANK
Unscrew the cap and add water to the tank, up to the WATER line. Next, add Shark HydroVac™ Multi-Surface
Concentrate, filling to the HYDROVAC CONCENTRATE line. Replace the cap and reinsert the tank until it clicks
into place. The top of the tank should be flush with the top of the body.
2
sharkclean .com
sharkclean .com
