Changing the Post Motor
Filter
1. Remove the post motor filter cover that is
located the rear of the unit. (Fig. 8)
• Filter should be cleaned at least twice
a year or when it becomes visibly soiled.
• Always operate the cleaner with the post
motor filter installed.
• Disconnect from electrical outlet before
cleaning the filter.
• Do not use a washing machine to rinse
the filter.
• Do not use a hair dryer to dry it.
• Always allow 24 hours to air dry.
Fig. 8
Fig. 10
Fig. 9
Full Dust Bag Indicator
The vacuum cleaner has a built-in pressure
safety valve. As soon as the dust bag is full
or the suction hose is blocked, the dust bag
full light will come on. If the suction power is
noticeably diminished, first check if the
suction hose is blocked. Then check if dust
bag is full. If this is the case, change it.
We
recommend that the dust bag be changed
when it is 2/3 full so that full suction can
be maintained.
Changing the Pre-Motor Filter
The pre-motor filter is located inside the
storage compartment behind the dust bag.
(Fig. 6)
•
The pre-motor filter should be cleaned at
least twice a year or when it becomes
visibly soiled.
•
Always operate the cleaner with the filter
installed.
•
Disconnect from electrical outlet
before cleaning the filter.
•
Do not use a washing machine to
rinse the filter.
•
Do not use a hair dryer to dry it.
•
Always allow 24 hours to air dry.
1. Press the storage compartment release
button and open the cover.
2. Remove the paper bag from the unit.
3. Pull the pre-motor filter assembly out of
the unit.
4. Remove the pre-motor filter from the
filter grill.
5. Rinse the pre-motor filter in lukewarm
water and let the pre-motor filter air dry
for 24 hours until it is completely dry.
(Fig. 7)
6. Replace the pre-motor filter into the filter
grill and replace back into the unit.
7. Replace the dust bag and close the
storage compartment cover.
Fig. 6
Fig. 7
OPERATING INSTRUCTIONS
PRECAUTIONARY MEASURES
Important
:
If the suction opening of the unit, the hose or the extension tubes are
BLOCKED
, switch off the vacuum cleaner and remove the blocking
substance before you start the unit again.
4.
When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
1.
Do not operate the vacuum
cleaner too close to heaters or
radiators.
5.
Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
2.
Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
6.
Do not use without all filters and dust
bag in place.
Note:
This vacuum cleaner is equipped
with a plug and power cord that retract
automatically. If the cord or plug get
damaged, it must be replaced by a
qualified technician.
2. Remove the post motor filter from the
filter grill. (Fig. 9)
3. Rinse the post motor filter in lukewarm
water and let the post motor filter air dry
for 24 hours until it is completely dry.
(Fig. 10)
4. Replace the post -motor filter into the
filter grill and replace back into the unit.
3.
Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the dust bag.
Warning:
Hold the plug when
rewinding the cord. Do not allow the
cord to whip when rewinding.
Pre-motor
filter
6
3
