Shark CD-2323, Инструкция по эксплуатации и каталог запасных частей, Страница: 12 / 24

cd 97-726 • rev. 7/07
PRESSURE
W
ASHER
Tr
oub
leshooting Guide
12
TRoUbleShooTINg
pRobleM poSSIble CaUSe SolUTIoN
loW opeRaTINg
pReSSURe
insufficient water supply use larger garden hose; clean filter washer at
water inlet.
old, worn or incorrect spray nozzle match nozzle number to machine and/or
replace with new nozzle.
plumbing or hose leak check plumbing system for leaks. re-tape
leaks with teflon tape.
Faulty or mis-adjusted unloader
valve (where applicable) adjust unloader for proper pressure. install
repair kit when needed.
Worn packing in pump install new packing kit (model 224).
model 22: call dealer customer support.
Fouled or dirty inlet or discharge
valves in pump clean inlet and discharge valves (model 224).
Worn inlet or discharge valves replace with valve kit (model 224).
model 22: call dealer customer support.
slow engine rpm set engine speed per specifications
(approximately 2800 rpm - 400 rpm).
flUCTUaTINg
pReSSURe
Valves worn check and replace if necessary (model 224).
Blockage in valve check and clean out if necessary (model
224).
Worn piston packing check and replace if necessary (model 224).
pump sucking air check that hoses and fittings are airtight. turn
off machine and pull trigger gun until a steady
flow of water emerges through the nozzle.
insufficient inlet water supply turn water on full force. check garden hose for
kinks, leaks or blockage.
pReSSURe loW
afTeR peRIod of
NoRMal USe nozzle worn check and replace if necessary
inlet or discharge valves blocked
or worn check and clean or replace if necessary.
unloader valve seat worn check and replace if necessary (model 224).
model 22: call dealer customer support.
pUMp NoISe
air suction line check water supply and connections on suc-
tion line.
Broken or weak inlet or discharge
valve springs check and replace if necessary.
Foreign matter in valves check and clean if necessary.
Worn bearings check and replace if necessary.
excessive temperature or liquid reduce to below 180°F (75°c).
pump is sucking air check that hoses and fittings are airtight. turn
off machine and purge pump by squeezing trig-
ger gun until a steady flow of water emerges
through the nozzle.